Rechercher

This document summarizes current scientific literature on the occurrence of macroplastics and microplastics, in the environment and biota. It gives an overview of testing methods, including sampling from various environmental matrix, sample preparation and analysis. Further, chemical and physical testing methods for the identification and quantification of plastics are described. This document…

Le présent document spécifie les exigences de sécurité et les moyens de les vérifier pour les chariots de manutention sans conducteur (ci-après dénommés chariots) et leurs systèmes. Des exemples de chariots de manutention sans conducteur (chariots de l'ISO 5053-1) peuvent également être connus comme: «véhicule autoguidé», «robot mobile autonome», «robot», «chariot autoguidé», «tunnel tugger…

This document gives guidelines on the design of navigation methods for selection menus with the use of a 4-direction device. The guidelines are applicable to any information equipment on which the display area is associated with a 4-direction device. This document also provides recommendations for parameters for display screen settings, character sets and languages in use. This document is not…

1 Scope 1.1 These requirements cover energy storage systems that are intended to receive and store energy in some form so that the energy storage system can provide electrical energy to loads or to the local/area electric power system (EPS) when needed. The types of energy storage covered under this standard include electrochemical, chemical, mechanical and thermal. The energy storage system…

This document specifies the general requirements and relevant test procedures for glove design and construction, innocuousness, comfort and efficiency, as well as the marking and information supplied by the manufacturer applicable to all protective gloves. It can also apply to arm protectors and gloves permanently incorporated in containment enclosures. Gloves and hand protectors such as mittens…

Le présent document spécifie des modes opératoires de mesure de la résistance à la flexion des papiers et des cartons au moyen d'un rigidimètre Taber. Le présent document est utilisé pour déterminer le moment de flexion nécessaire pour fléchir d'un angle de 15° l'extrémité libre d'une éprouvette de 38 mm de large, fixée verticalement, lorsque la charge est appliquée à une…

This document specifies guide values for the calculation of tilting pad thrust bearings as described in ISO 12130-1. The empirical values given can be modified for specific fields of application. This document is not applicable to heavily loaded tilting pad thrust bearings.

Le présent document définit les exigences générales et les méthodes d'essai concernant la conception et la construction du gant, l'innocuité, le confort et l'efficacité, ainsi que le marquage et les informations fournies par le fabricant applicables à tous les gants de protection. Le présent document peut aussi s'appliquer aux protecteurs du bras et aux gants incorporés de…

This document specifies procedures to measure the bending resistance of paper and paperboard using a Taber-type tester. This document is used to determine the bending moment required to deflect the free end of a 38 mm wide vertically clamped specimen by 15° when the load is applied at a bending length of 50 mm. For boards that tend to be permanently deformed if bent through 15°, the half bending…

This document gives guidelines on the design of navigation methods for selection menus with the use of a 4-direction device. The guidelines are applicable to any information equipment on which the display area is associated with a 4-direction device. This document also provides recommendations for parameters for display screen settings, character sets and languages in use. This document is not…