Rechercher

Defines a method for evaluating these products to indicate the effectiveness in preventing the rusting of ferrous parts should water becomes mixed the oil/fluid. The methodis for application to inhibited oils including steam turbine oils, circulating oils and hydraulic oils and non-hydrocarbon fluids including fluids denser than water.

ISO 13985:2006 specifies the construction requirements for refillable fuel tanks for liquid hydrogen used in land vehicles as well as the testing methods required to ensure that a reasonable level of protection from loss of life and property resulting from fire and explosion is provided. It is applicable to fuel tanks intended to be permanently attached to land vehicles.

This document specifies the general requirements for evaluating the vibration of various coupled industrial machine types with a power above 15 kW and operating speeds between 120 r/min and 30 000 r/min when measurements are made in-situ. Guidelines for applying evaluation criteria are provided for measurements taken on non-rotating and rotating parts under normal operating conditions. The…

This document establishes the requirements for technical reviews and audits to be performed throughout the acquisition life cycle for the US Department of Defense (DoD) and other defense agencies. This document provides the definition, description, and intent, as well as the entry, exit and success criteria, for each technical review and audit. It is to be used to establish agreement between…

ISO 20816-1:2016 establishes general conditions and procedures for the measurement and evaluation of vibration using measurements made on rotating, non-rotating and non-reciprocating parts of complete machines. It is applicable to measurements of both absolute and relative radial shaft vibration with regard to the monitoring of radial clearances, but excludes axial shaft vibration. The general…

This document specifies a framework for mass customization value chain management, including the framework model, functions and information flow of mass customization. This document does not describe interoperability at a system level or interoperability throughout the life cycle in detail.

Applies to the samples taken from bulk aluminium ores. Annex A specifies a method to be used when it is difficult to carry out sieving, crushing and dividing owing to the sample being adhesive or excessively wet. Annex B specifies methods of correction for sprayd water and/or rainfall.

This document provides guidelines for the planning, design and construction of a cylindrical tank constructed on the ground with prestressed concrete (PC) for use with potable water tank. This document is applicable to PC tanks for potable water with a capacity of 30 000 m3 or less and the diameter-to-height ratio (D/H) from 1,0 to 3,0. NOTE When designing and constructing a tank not covered by…

This document is applicable to road vehicles with automated driving functions. The document specifies the logical interface between in-vehicle environmental perception sensors (for example, radar, lidar, camera, ultrasonic) and the fusion unit which generates a surround model and interprets the scene around the vehicle based on the sensor data. The interface is described in a modular and semantic…

This document specifies two methods for the determination of cold flow characteristics of raw polybutadiene rubber (BR): — Method A is a stress relaxation method using the rotorless rheometer; — Method B is a creep testing method using compression assembly.