Informatique de santé — Management de la sécurité de l'information relative à la santé en utili...
L'ISO 27799 :2016 donne des lignes directrices en matière de normes organisationnelles relatives à la sécurité de l'information et des bonnes pratiques de management de la sécurité de l'information, incluant la sélection, la mise en ?uvre et la gestion de mesures de sécurité prenant en compte le ou les environnement(s) à risques pour la sécurité de l'information de l'…
Health informatics — Information security management in health using ISO/IEC 27002
ISO 27799:2016 gives guidelines for organizational information security standards and information security management practices including the selection, implementation and management of controls taking into consideration the organization's information security risk environment(s).
It defines guidelines to support the interpretation and implementation in health informatics of ISO/IEC 27002…
L'ISO 8666 :2016 établit les définitions des dimensions principales et des caractéristiques qui leur sont associées ainsi que les définitions des spécifications de masse et des conditions de chargement. Elle s'applique aux petits navires d'une longueur de coque (LH) inférieure ou égale à 24 m.
Information technology — Security techniques — Blind digital signatures — Part 2: Discrete logarithm...
ISO/IEC 18370-2:2016 specifies blind digital signature mechanisms, together with mechanisms for three variants of blind digital signatures. The variants are blind digital signature mechanisms with partial disclosure, blind digital signature mechanisms with selective disclosure and traceable blind digital signature mechanisms. The security of all the mechanisms in ISO/IEC 18370-2:2016 is based on…
Acoustics — Objective method for assessing the audibility of tones in noise — Engineering method
ISO/PAS 20065:2016 describes a method for the objective determination of the audibility of tones in environmental noise.
It is intended to augment the usual method for evaluation on the basis of aural impression, in particular, in cases in which there is no agreement on the degree of the audibility of tones. The method described can be used if the frequency of the tone being evaluated is equal to…
Air cargo — Non-certified lower deck containers — Design and testing
ISO 4118:2016 covers the design, performance and testing requirements for lower deck containers for use in main line aircraft which do not require airworthiness approval/certification when loaded under the conditions of compartment restraint and/or where applicable according to the aircraft type's approved Weight and Balance Manual, ISO 8097 or ISO 21100 equivalent base plate restraint for…
Composite suspension insulators for overhead lines > 75 kV
1.1
This Standard applies to suspension and dead-end composite insulators used on ac overhead transmission lines with a nominal voltage greater than 75 kV and a frequency not greater than 100 Hz.
1.2
This Standard specifies
a)
insulator characteristics (mechanical, electrical, and dimensional) and prescribe the conditions under which these characteristics are to be verified;
b)
test…
1.1
This Standard covers the requirements for guy composite insulators used in guy wires on overhead distribution lines operating at nominal voltages up to and including 75 kV. Guy insulators insulate or isolate guy wires for corrosion protection, higher insulation levels, clearances for maintenance and normal operation, and safety for the public and workers (joint-use). Guy composite insulators…
Safety requirements for electrical equipment for measurement, control, and laboratory use — Part 2-0...
This is the second edition of CAN/CSA-C22.2 No. 61010-2-040, Safety requirements for electrical
equipment for measurement, control, and laboratory use — Part 2-040: Particular requirements for
sterilizers and washer-disinfectors used to treat medical materials, which is an adoption, with Canadian
deviations, of the identically titled IEC (International Electrotechnical Commission) Standard…
Safety of power converters for use in photovoltaic power systems — Part 1: General requirements
This is the first edition of CAN/CSA-C22.2 No. 62109-1, Safety of power converters for use in
photovoltaic power systems — Part 1: General requirements, which is an adoption, with Canadian
deviations, of the identically titled IEC (International Electrotechnical Commission) Standard 62109-1
(first edition, 2010-04). It is one in a series of Standards issued by CSA Group under Part II of the…
