Rechercher

IEC TR 63074:2019 gives guidance on the use of IEC 62443 (all parts) related to those aspects of security threats and vulnerabilities that could influence functional safety implemented and realized by safety-related control systems (SCS) and could lead to the loss of the ability to maintain safe operation of a machine. Considered security aspects of the machine with potential relation to SCS are…

IEC 62812:2019 specifies methods of measurement and associated test conditions that eliminate or reduce the influence of adverse phenomena in order to improve the attainable accuracy of low-resistance measurements. The methods described in this document are applicable for the individual measurements of the resistance of individual resistors, and also for resistance measurements as part of a test…

L'IEC 62812:2019 spécifie les méthodes de mesure et les conditions d'essai associées qui éliminent ou réduisent l'influence des phénomènes défavorables afin d'améliorer la précision réalisable des mesures de faibles résistances. Les méthodes décrites dans le présent document s'appliquent aux mesures individuelles de la valeur de résistances individuelles, ainsi qu'…

IEC 62148-19: 2019 covers the photonic chip scale package. The purpose of this document is to specify adequately the physical requirements of optical transmitters and receivers that will enable mechanical interchangeability of transmitters and receivers. Keywords: physical interface for photonic chip scale packages

L'IEC 62148-19: 2019 couvre les boîtiers à puces photoniques. L'objectif du présent document est de spécifier les exigences physiques des modules d'émission et de réception optique qui permettent l'interchangeabilité mécanique des émetteurs et transmetteurs. Mots-clés: interface physique des boîtiers à puces photoniques

IEC TS 62998-1:2019 gives requirements for the development and integration of safety related sensors (SRS) and safety related sensor systems (SRSS) used for protection of persons with special attention to systematic capabilities. This generic standard only applies if – protection of persons is to be performed by using sensors, and – standards for functional safety of electrical control systems…

This document describes the data link layer (DLL) and physical layer (PHY) for the two CAN-based network interfaces specified in the 11992-series. The DLL sub-clauses are composed of: — DLL protocol entity requirements; — DLL device interface requirements; and — DLL network system requirements. Normally, the physical signalling sub-layer is implemented in the CAN…

This standard applies to three grades of aviation turbine fuel (military grades F-34, F-37 as its equivalent, and F-44) consisting of conventional hydrocarbons, synthetic hydrocarbons, naturally occurring non-hydrocarbons and additives as specified herein. Grade F-34 is a kerosene-type aviation turbine fuel, and grade F-44 is a high-flash kerosene-type aviation turbine fuel. Kerosene-type…

La présente norme s’applique à trois grades de carburéacteur d’aviation (grades militaires F-34, F-37 son équivalent et F-44) constitués d’hydrocarbures classiques, d’hydrocarbures synthétiques, de produits d’origine naturelle autres que des hydrocarbures de pétrole et des additifs indiqués dans la présente norme. Le grade F-34 est un carburéacteur d’aviation de type kérosène et le grade F-44…

1 Scope 1.1 This Standard specifies the requirements for cord-connected and permanently connected industrial type heating equipment that is intended to be used in ordinary locations in accordance with CSA C22.1, Canadian Electrical Code, Part I (CE Code, Part I) and rated 600 volts or less. 1.2 This Standard applies to a) heat treating and other special-use furnaces; b) infrared…