Specifies the requirements of winter savory in the form of sprigs, and whole or broken leaves. Does not apply to summer savory. Annexes A (recommendations to storage and transport conditions) and B are for information only.
Sterilization of health-care products — Ethylene oxide — Requirements for the development, validatio...
ISO 11135:2014 specifies requirements for the development, validation and routine control of an ethylene oxide sterilization process for medical devices in both the industrial and health care facility settings, and it acknowledges the similarities and differences between the two applications.
Acoustics — Hearing aid fitting management (HAFM) — Part 1: General process
This document applies to hearing aid fitting management (HAFM) services offered by hearing aid professionals (HAP) when providing benefit for their clients. The provision of hearing aids relies on the knowledge and practices of a hearing aid professional, to ensure the proper fitting and adequate service in the interest of the client with hearing loss.
This document specifies general processes of…
Plastics piping systems for pressure and non-pressure water supply, drainage or sewerage — Glass-rei...
ISO 25780:2011 specifies the properties of the piping system and its components made from glass-reinforced thermosetting plastics (GRP) based on unsaturated polyester resin (UP) for water supply, irrigation, drainage or sewerage systems with or without pressure.
ISO 25780:2011 is applicable to GRP-UP piping systems, with flexible joints, intended to be installed using jacking techniques. It…
Resilient, textile, laminate and modular mechanical locked floor coverings — Castor chair test
ISO 4918:2016 specifies methods for determining the change of appearance and stability of a textile floor covering or any damage caused by detachment of layers, opening of joints, or crazing of a resilient or laminate floor covering under the movement of a castor chair.
Assembly tools for screws and nuts — Hand torque tools — Part 2: Requirements for calibration and de...
This document specifies the method for the calibration of hand torque tools and describes the method of calculation of measurement uncertainties for the calibration.
It also specifies the minimum requirements for a certificate of calibration to this standard for hand torque tools.
The Annex C of this document specifies the minimum requirements for the calibration of the torque measurement device…
Privacy protection — Guidance on the use of models for privacy engineering
This document provides guidance on how to use modelling in privacy engineering.
It describes categories of models that can be used, the use of modelling to support engineering, and
the relationships with other references and standards for privacy engineering and for modelling.
It provides high-level use cases describing how models are used.
Additive manufacturing — Qualification Principles — Framework for categorizing resources and process...
This document defines a standardized framework for implementing a level system for temporarily self-sufficient systems in additive manufacturing. It defines principles, criteria, and provides guidance for categorizing additive manufacturing processes and technologies into different levels to support self-sufficient systems such as ships, oilrigs and assembly teams in the field or remote research…
Petroleum products and lubricants — Petroleum oils and other fluids — Determination of rust-preventi...
Defines a method for evaluating these products to indicate the effectiveness in preventing the rusting of ferrous parts should water becomes mixed the oil/fluid. The methodis for application to inhibited oils including steam turbine oils, circulating oils and hydraulic oils and non-hydrocarbon fluids including fluids denser than water.
