Rechercher

Scope 1.1 This Standard applies to motor-operated liquid pump units for use in nonhazardous, indoor, outdoor (exposed), and submerged locations and designed to be used in accordance with the Rules of the Canadian Electrical...

.1 This Standard covers manual transfer panels having maximum ratings of 250 V, 60 A, for use in non-hazardous locations in accordance with the Canadian Electrical Code, Part I. 1.2 This Standard covers manual transfer panels...

.1 This test method determines the wind uplift resistance of membrane-roofing systems when subjected to dynamic wind load cycles. The test methods are applicable to a) mechanically attached membrane roofing systems; and b)...

1.1 This Standard applies to a complete cablebus system (termination to termination) and associated fittings rated at not more than 46 kV and intended for use in accordance with the Canadian Electrical Code, Part I and...

1.1 This Standard applies to solid-state lighting controls rated at 600 V and less, with or without an integral switching (disconnecting) device, designed to be used in circuits a) for the control of incandescent lamps; and b...

1.1 This Standard applies to (a) steam sterilizers that (i) have a chamber volume of 42.5 L (1.5 ft3) or greater; and (ii) are intended for use in health care facilities; (b) emergency (flash) sterilizers; and (c) washer...

1.1 This Standard covers manual transfer panels having maximum ratings of 250 V, 60 A, for use in non-hazardous locations in accordance with the Canadian Electrical Code, Part I. 1.2 This Standard covers manual transfer...

1.1 General This Standard provides requirements for the design and evaluation of building components of fibre-reinforced polymers (FRP) in buildings and of building components reinforced with FRP materials. It is based on...

1.1 This Standard provides a calculation method for determining the heat loss and heat gain of buildings (as described in Clause 1.3 below) for the purpose of selecting the appropriate output capacity of a space heating...

1.1 This Standard specifies general requirements, test methods, and markings for whirlpool and air-jetted bathtubs and suction fittings used in hydromassage bathtub systems that incorporate a bathtub and circulation pump. The...

1.1 This Standard specifies the requirements for distribution transformers intended primarily for operation by electric utilities. Note: The operation of transformers complying with this Standard by other than an electric...

1.1 This Standard specifies procedures for 24 h simulated-use testing of gas-fired instantaneous water heaters. This Standard also provides calculations for the determination of (a) the maximum L/min (gpm) rating; (b)...