Rechercher

1.1 This Standard applies to luminaires for use in non-hazardous locations and that are intended for installation on branch circuits of 600 V nominal or less between conductors in accordance with the Canadian Electrical Code...

.1 These requirements cover FITTINGS for use with cable and conduit intended for installation in accordance with the National Electrical Code, ANSI/NFPA 70, the Canadian Electrical Code (CEC), Part I, CSA C22.1, and the...

1.1 These requirements cover FITTINGS for use with cable and conduit intended for installation in accordance with the National Electrical Code, ANSI/NFPA 70, the Canadian Electrical Code (CEC), Part I, CSA C22.1, and the...

This clause of Part 1 is replaced by the following. This International Standard deals with the safety of sealed (hermetic and semi-hermetic type) motorcompressors, their protection and control systems, if any, which are...

1.1 General This standard is divided into seven clauses that cover requirements for skin effect trace heating when installed in ordinary locations as well as in hazardous (classified) locations. Clause 1 provides the scope...

1.1 This Standard specifies minimum requirements for masonry materials and masonry construction. Notes: (1) Requirements for structural design of masonry are specified in CSA S304.1. (2) If a requirement specified in Part 9...

1.1 This Standard specifies requirements for the following in health care facilities: (a) hydraulic fire protection systems; (b) pure water systems; (c) drainage systems; and (d) plumbing fixtures and fittings. Note: See CAN...

1.1.1 This standard applies to newly produced vented gas-fired space heating appliances (see Part XII, Definitions), hereinafter referred to as appliance(s), constructed entirely of new, unused parts and materials, and having...

1.1 This standard applies to newly produced automatic valves (Section 3, Definitions) constructed entirely of new, unused parts and materials. These valves may be individual automatic valves or valves utilized as parts of...

1.1 This Standard applies to the design of aluminum alloy members and assemblies intended to carry a known load. 1.2 This Standard specifies requirements for the design of members to meet the requirements of the National...