Chauffage par trace à effet de peau des pipelines, des navires, des équipements et des structures - Exigences générales, d'essai, de marquage et de documentation

1.1 General 
This standard is divided into seven clauses that cover requirements for skin effect trace heating when installed in ordinary locations as well as in hazardous (classified) locations. Clause 1 provides the scope, purpose, and typical applications. Clause 2 lists normative references to other standards that are indispensable in applying this standard. Clause 3 provides definitions that are either not found in other standards or have been modified for use with this standard. Clause 4 establishes general system requirements for skin effect trace heating. Clause 5 provides both type and routine testing requirements for skin effect insulated conductors and other skin effect system components. Clause 6 covers marking requirements. Clause 7 details additional documentation requirements. 

This standard also contains annexes. Annex A provides bibliographical references. Annex B provides additional requirements for installations that are in explosive atmospheres classified using the Division method of area classification. Annex C provides additional requirements in explosive areas classified using the Zone method of area classification. Annex D covers skin effect trace heating design verification methodologies. 

1.2 Scope 
This standard applies to general, testing, marking, and documentation requirements for skin effect trace heating systems rated up to and including 5 kVac and 260 °C maximum skin effect insulated conductor temperature. These heating systems are intended for installation in accordance with the CSA C22.1, Canadian Electrical Code, Part I (CE Code); NFPA 70, National Electrical Code® (NEC®) in the USA; or with any other national electrical installation code, as applicable. 

This standard applies to skin effect trace heating systems intended to be installed in ordinary and hazardous locations. The hazardous locations include the following: 
 

• In Canada: Zone 1; Zone 2; Zone 21; Zone 22; or Class I, Division 2; Class II, Division 2; Class III, Division 2 as described in CSA C22.1. 
• In the USA: Class I, Zone 1; Class I, Zone 2; Zone 21 and Zone 22; or Class I, Division 2; Class II, Division 2; Class III, Division 2 as described in the NEC. 

This standard also applies to termination assemblies and control methods used with skin effect trace heating systems. 

NOTE 1: Requirements for certification at voltages above 5 kVac or skin effect insulated conductor insulation temperatures above 260 °C may be considered under a special investigation by an accredited certification body. 

NOTE 2: Information on transformer, power distribution, and controls components can be found in IEEE Std 844.2/CSA C293.2.