Rechercher

1.1 This Standard applies to permanent adhesive labels and nameplates intended for use indoors or outdoors on application surfaces that are essentially clean, smooth, flat, or simple curved.* * See Annex A 1.2 This Standard...

1.1 This Standard specifies requirements for copper and aluminum conductor secondary and service- entrance cables intended for use on systems having a nominal voltage of 600 V or less in underground installation a) by direct...

A3001-13 - Cementitious materials for use in concrete Scope 1.1 This Standard addresses the following aspects of cementitious materials: (a) their definitions; (b) their chemical, physical, and uniformity requirements; (c)...

Scope 1.1 This Code specifies requirements for the installation, alteration, and maintenance of solid-fuel-burning appliances and equipment installed indoors or outdoors. 1.2 In this Code solid-fuel-burning appliances include...

Scope This International Standard specifies methods of measurement of electrical power consumption in standby mode(s) and other low power modes (off mode and network mode), as applicable. It is applicable to electrical...

Scope 1.1 This Standard specifies design, testing, and marking requirements for manufactured fall arresters for single users and for manufactured vertical lifelines that are used on a vertical or slope plane. 1.2 The...

.1 This Standard specifies test procedures to determine the performance of general service directional lamps. Note: This Standard is intended to be technology neutral. 1.2 This Standard does not include requirements for...

.1 Objective 1.1.1 This Standard contains requirements for reinforced thermosetting resin conduit (RTRC) of the extra heavy wall type (XW) in trade sizes 3/4-6 (metric designators 21-155). 1.1.2 Products covered by this...

1.1 This Standard applies to expandable sleeving rated at 90°C, 105°C, 125° C, 150°C and 200°C for bundling of insulated wires and cables, intended for the use in equipment designed to be installed and used in accordance with...

1.1 This Standard specifies requirements for single- and multi-conductor insulated cables having metallic interlocked armour without an overall jacket (Type AC90 or ACG90) or with an overall jacket (Type ACWU90 or ACGWU90)...

The ISO/IEC 10373 series defines test methods for characteristics of identification cards according to the definition given in ISO/IEC 7810. Each test method is cross-referenced to one or more base standards, which can be ISO...

1.1 This Standard covers three-phase, alternating current, salient pole synchronous machines 150 kW and up, 200 through 13,800 volts, 60 and 50 Hertz and will assist in verifying the machine efficiency has been maintained...