Rechercher

1.1 This Standard specifies the requirements for single-phase, pad-mounted distribution transformers with separable insulated high-voltage connectors and intended primarily for operation by electric utilities. Note: The...

Scope 1.1 This standard applies to metallic (copper, steel and stainless steel) press-connect type fittings, and valves (hereafter referred to as fittings unless otherwise specified) for use with fuel gas systems intended for...

1.1 This Standard covers cord connected, direct plug-in and receptacle type SPDs whose primary function is to provide surge protection and that are intended to be marked SPD Type 3 in accordance with Clause 5.2 a). This...

Details test and examination criteria for manually-operated gas valves, not exceeding 4 inches (102 mm) pipe size, and pilot shut-off devices, except for hose end valves and appliance connector valves, intended to be used as...

1.1 This Standard specifies the requirements for single-phase, pad-mounted distribution transformers with separable insulated high-voltage connectors and intended primarily for operation by electric utilities. Note: The...

1.1 Cette norme spécifie les exigences relatives aux transformateurs de distribution monophasés montés sur socle, munis de connecteurs haute tension isolés séparables et destinés principalement à être exploités par des...

Remarque : Le titre et le champ d'application de cet avis d'intention (publié initialement le 24 juin 2025) ont été mis à jour par l'organisme de normalisation responsable le 12 août 2025. Une période de commentaires...

.1.1 This standard applies to manually-operated gas valves (see Part IV, Definitions), hereinafter referred to as valves, not exceeding 4 in (102 mm) pipe size, and pilot shut-off devices (see Part IV, Definitions)...

This standard provides basic procedures based on joint ultimate load or a limiting slip for the determination of the lateral strength resistance and lateral slip resistance of truss pate teeth embedded in sawn and structural...