Rechercher

1.1 This Standard covers material, manufacturing, and class dimensional requirements for seasoned wood poles and reinforcing stubs that are primarily intended for the support of electrical power or communication lines. 1.2...

1.1 This Standard applies to cords and cord sets intended for indoor use to electrically connect communication systems that have a normal operating voltage-to-ground of less than 150 V rms, and that are installed or used in...

1.1 This Standard applies to single- and multiple-conductor fire alarm and signal cables with a maximum nominal voltage rating of 300 V and a minimum temperature rating of 60 ° C for use in buildings and other structures in...

1.1 This International Standard specifies requirements for low-pressure hose assemblies intended for use with the following medical gases: - oxygen; - nitrous oxide; - medical air; - helium; - carbon dioxide; - xenon; -...

1.1 Purpose This International Standard defines a Petri net technique, called High-level Petri Nets, including its syntax and semantics. It provides a reference definition that can be used both within and between...

1.1 This Standard applies to single-conductor and multi-conductor Type RA90 and RC90 cables having a maximum temperature rating of 90 °C in both dry and wet locations and intended for installation in accordance with the Rules...

1.1 This Standard covers drinking water treatment systems that are (a) point-of-use or point-of-entry plumbed systems; and (b) point-of-use non-plumbed systems. Note: Drinking water treatment systems covered by this Standard...

Scope 1.1 This Standard covers drinking water treatment systems that are (a) point-of-use or point-of-entry plumbed systems; and (b) point-of-use non-plumbed systems. Note: Drinking water treatment systems covered by this...

1.1 The purpose of this Standard is to specify pool pump performance measurements that will facilitate the selection of the most efficient models for performing the combined functions of filtration and pool cleaning. 1.2 This...

1.1 This Standard specifies requirements for the installation of packaged solar domestic hot water (SDHW) systems that meet the requirements of the CSA F379 Series. Note: SDHW systems include those designed to (a) provide hot...

.1 This Standard specifies requirements for measuring the thermal efficiency, electric power consumption, and power factor of gas-fired unit heaters with a maximum input rate of 2 931 kW (10 000 000 Btu/h) or less (including...

1.1 This Standard applies to woodlots and small forests up to 4000 hectares that have a management plan; these are termed "defined woodlots" (see Clause 3). It provides sustainable forest management requirements for (a) a...