Rechercher

.1 This Standard specifies the requirements for cord-connected and permanently connected, industrial type heating equipment intended to be used in ordinary locations in accordance with CSA C22.1, Canadian Electrical Code...

1.1 This Standard applies to locking type plugs, receptacles, equipment power inlets and outlets, and connectors rated up to 60 A and up to 600 V ac or 250 V dc, for use in accordance with the Canadian Electrical Code, Part I...

1.1 This Standard applies to both cord-connected and permanently connected storage-tank water heaters, having tanks less than 610 mm inside diameter, for use on nominal system voltages of 600 V and less, and designed to be...

1) This Technical Report describes extensions to the C++ standard library that is described in the International Standard for the C++ programming language [14]. 2) This Technical Report is non-normative. Some of the library...

This Technical Report specifies the transmission performance for channels to support 10GBASE-T, specifies the methods to assess whether installed Class E and Class F channels meet 10GBASE-T requirements,provides mitigation...

This standard specifies testing and labelling requirements for manufacturers of hip protectors used to reduce the risk of hip fracture in the event of a fall. Some of the requirements include product placement guidelines...

This part of IEC 61400 presents measurement procedures that enable noise emissions of a wind turbine to be characterised. This involves using measurement methods appropriate to noise emission assessment at locations close to...

This Standard specifies requirements for single-use and reusable sharps containers intended to hold potentially hazardous sharps medical waste with or without sharps protection features, e.g., scalpel blades, trocars...

1. Revise Test Method and MEPS for types A and B. 2. Re-aligning types and scopes for refrigerated types to match NRCan and DOE. The aggregate scope of the types in C804 would not be reduced. 3. Include high efficiency MEPS...

This part of IEC 60079 specifies the requirements for the design, construction, testing and marking of electrical equipment and Ex Components with type of protection increased safety "e" intended for use in explosive gas...

IEC 60601-2-28:2017 applies to the basic safety and essential performance of X-ray tube assemblies and to components thereof, intended for medical diagnosis and imaging. Where the general standard IEC 60601-1 and the...

This clause of Part 1 is applicable, except as follows: Addition: This part of IEC 62841 applies to hand-held routers intended for cutting slots into or shaping the edge of wood and analogous materials, plastics and non...