Évaluation des propriétés des matériaux polymères

1.1 
This Standard provides procedures for evaluating polymeric materials and parts made from polymeric 
materials intended for application in electrical equipment covered by the Canadian Electrical Code, Part II (CE 
Code, Part II), with respect to: 

a) flammability; 
b) mechanical properties; 
c) thermal properties; 
d) resistance to weathering; and 
e) electrical properties. 

1.2 
The test procedures listed in this Standard are provided for reference in the Standards forming Part II of the 
Canadian Electrical Code.  Although the verbal auxiliary “shall” is used to state the requirements of each test 
procedure given, it is essential to recognize that the procedures are nonmandatory in themselves unless 
mandated by individual Standards. 

Note: Many of these procedures are recognized internationally for evaluating polymeric materials and are equally applicable to areas  other than electrical. 

1.3 
This Standard provides procedures for making reproducible observations and serves as an aid in classifying 
materials according to the criteria set forth in the individual Standards. 

1.4 
The procedures described in this Standard involve standard-size specimens tested under laboratory 
conditions and are intended to be used solely to measure and describe the properties of material.  They are intended to serve as a preliminary indication of the material’s acceptability for a particular application . The performance level of a material by these methods may vary in the end use application. 

1.5 
Test procedures for classifying electrical wires and cables are not specified in this Standard. 

1.6  
The test methods described in this Standard involve procedures to assess material integrity, electrical 
properties and reaction to fire.  

1.7 
The evaluation of component parts for electrical applications that are produced using Additive Manufacturing 
(AM) processes shall be evaluated under the appropriate clauses of this standard where deemed applicable.  

Notes: 
1) This Standard may involve hazardous materials, operations, and equipment. This Standard does not purport to address all of the  safety problems associated with its use. It is the responsibility of the user of this Standard to establish appropriate safety and  health practices and determine the applicability of regulatory limitations prior to use. 

2) This Standard should be used to measure and describe the properties of materials, products, or assemblies in response to heat and flame under controlled laboratory conditions and should not be used to describe or appraise the fire hazard or fire risk of materials, products, or assemblies under actual fire conditions. However, results of each test may be used as an element of a fire risk assessment that takes into account all of the pertinent factors of a particular end use. 

3) The test methods described in this Standard are not intended to assess fire hazard. The fire hazard created by materials depends upon the form and end use of the material. Assessment of fire hazard includes, but is not limited to, many factors, such as ease of ignition, burning rate, flame spread, fuel contribution, intensity of burning, and products of combustion.