Rechercher

This document describes the procedures and the precautions to be taken in drawing representative samples of ethylene in the liquid phase stored at -100 °C and in the gaseous phase, for the purpose of their analysis. Annex A sets out a diagrammatic representation of a system for the disposal of the portion of the sample which is not used in the analysis.

IEC TR 62899-302-5:2023 provides the significant characteristics, parameters and system properties that are relevant for functional inkjet printing for printed electronics. Where possible, existing measurement standards and specifications are cited.

1 Scope 1.1 General This Standard concerns high-pressure containers for the on-board storage of natural gas as a fuel for automotive vehicles. This Standard contains requirements for the material, design, manufacture, and testing of serially produced, refillable Type NGV 2 containers intended for the storage of compressed natural gas (CNG) for vehicle operation. These containers are to be…

1 Scope 1.1 General This Standard applies to the protection of workers from the hazards arising from the use of mobile or stationary machinery. It provides the criteria to be observed and the description, selection, and application of guards and protective devices. Where a current CSA standard exists for a specific type of machinery (e.g., CSA B167, CAN/CSA-B354.2, CSA M424.1, CSA Z142, CSA…

1 Scope 1.1 Application This Standard specifies requirements for the selection and installation of backflow preventers. Additional information on how backflow due to back siphonage and back pressure occurs, and how to select and apply specific devices, is included in Annexes A, B, and C. 1.2 Exclusions 1.2.1 Product exclusions This Standard does not cover a) construction requirements or…

1 Scope 1.1 This Standard applies to all types of electric cranes, including electric overhead travelling cranes, and hoists for vertical lifting and lowering of freely suspended load for voltages of 750 V and less between conductors. The equipment specified in this Standard is intended for installation in accordance with the Canadian Electrical Code, Part I. 1.2 This Standard applies to the…

1 Scope 1.1 This Part is intended to be read together with the Standard for Fuseholders – Part 1: General Requirements, hereafter referred to as Part 1. The titles of the Clauses in this Part correspond to the similarly titled Clauses in Part 1. The requirements of Part 1 apply unless modified by this Part. For the Part 1 requirements, refer to the Standard for Fuseholders – Part 1: General…

Scope This National Standard of Canada applies to four types of middle distillate fuel oils that are suitable for use in liquid fuel burning equipment without preheating [types 0, 1, 2 and 2(B6-B20)], and three types of fuel oils that contain residual fuel components that require preheating (types 4, 5 and 6). The heating fuel oils covered by this standard are intended for use in oil burning…