Hydraulic fluid power — Determination of derived displacement of positive displacement pumps and mot...
This document specifies the zero-pressure intercept method for the determination of the derived displacement of hydraulic fluid power positive displacement pumps and motors under steady state conditions. A single value for the derived displacement is determined from measurements at a single shaft speed.
Plastics — Guidelines for the recovery and recycling of plastics waste — Part 5: Organic/biological ...
This document establishes the terms, definitions, methodologies, and calculations that are necessary for the recovery of waste from plastic products and materials labelled as industrially compostable (hereafter referred to as compostable plastic waste) through organic recycling. The document identifies the different types of organic recycling technologies used in the recovery and subsequent…
Plastics — Smoke generation — Determination of optical density by a single-chamber test
ISO 5659-2:2017 specifies a method of measuring smoke production from the exposed surface of specimens of materials or composites. It is applicable to specimens that have an essentially flat surface and do not exceed 25 mm in thickness when placed in a horizontal orientation and subjected to specified levels of thermal irradiance in a closed cabinet with or without the application of a pilot…
Green coffee — Guidance on methods of specification
ISO 9116 gives guidance on methods to be used to describe green coffee for sale and purchase, and is based on the terms of contract used in the international coffee trade.
It also recommends procedures for sampling, packing, marking, storage and shipping of green coffee.
It is applicable to green coffee as defined in ISO 3509.
Green coffee — Olfactory and visual examination and determination of foreign matter and defects
ISO 4149:2005 specifies methods for the olfactory and visual examination and for the determination of foreign matter and defects in green coffee from all origins, in order to assess conformity with a specification or a contract. These methods can also be used for determining one or more of the characteristics of green coffee with an impact on coffee quality for technical, commercial,…
Green coffee — Determination of loss in mass at 105 °C
ISO 6673 specifies a method for the determination of the loss in mass at 105 °C of green coffee.
It is applicable to decaffeinated and non-decaffeinated green coffee as defined in ISO 3509.
This method of determining the loss in mass can be considered, by convention, as a method for determining the water content and can be used as such by agreement between the interested parties, but it gives…
Implants for surgery — Partial and total hip joint prostheses — Part 12: Deformation test method for...
This part of ISO 7206 specifies a test method for determining short-term deformation of a press-fit acetabular component for total hip joint replacement under specific laboratory conditions. It also defines the conditions of testing so that the important parameters that affect the components are taken into account and it describes how the specimen is set up for testing.
The described method is…
Meteorology — Radiosonde — Part 1: Laboratory test method for calibration error of temperature senso...
This International Standard proposal specifies technical requirements and test method for temperature sensor in radiosonde. This International Standard is applicable to the temperature measurement traceable to SI unit in boom sensors according to variations of pressure and air speed under the simulated conditions of upper air.
This proposed standard will mainly provide
a) Terms and definitions…
Matériaux métalliques — Essai de traction à vitesses de déformation élevées — Partie 1: Systèmes de ...
ISO 26203-1:2018 spécifie des méthodes pour les essais des tôles de matériaux métalliques en vue de déterminer les caractéristiques contrainte-déformation à vitesses de déformation élevées. Ce document couvre l'utilisation des systèmes d'essai de type à barre élastique.
La gamme de vitesses de déformation entre 10−3 s−1 et 103 s−1 est considérée être la plus pertinente pour les…
