Medical electrical equipment. Part 2: Particular requirements for the safety of baby incubators
This standard establishes safety requirements for baby incubators with the view to minimizing hazards to the patient and user. It also specifies tests by which compliance requirements can be verified. It does not apply to transport incubators nor infant radiant warmers which are covered in other publications.
Medical electrical equipment. Part 2: Particular requirements for the safety of transport incubators
This standard establishes safety standards for the safety of transport incubators which minimize hazards to the patient and user. lt also specifies tests to verify compliance with the requirements. It does not apply to baby incubators or radiant warmers.
Acoustics — Hearing protectors — Part 1: Subjective method for the measurement of sound attenuation
Specifies a method for measuring sound attenuation at the threshold of hearing. The procedure is designed to yield values close to the maximum attenuation which are not normally attained under field conditions. The values reflect the attenuating characteristics only to the extent that users wear the device in the same manner as did the test subjects. Data are collected at low sound pressure…
Mechanical vibration and shock — Analytical methods of assessing shock resistance of mechanical syst...
Establishes the procedures for specifying the analytical methods, provides a protocol for conducting and documenting a shock analysis and identifies the requirements of the protocol. Applies to any product or human subject for which an analytical assessment of its shock resistance is required. The term "product" is used to designate an engineering artifact (equipment, component, machine…
Workplace air — Determination of particulate lead and lead compounds — Flame atomic absorption spect...
The method is applicable to the determination of masses of 10 µg to 200 µg of lead per sample using the normal procedure without dilution. The concentration range for lead in air for which this procedure is applicable is determined in part by the sampling procedure selected by the user. The method is applicable to personal and fixed location sampling. The normal sample dissolution procedure is…
Firefighter Dress Uniform (Federal Public Service)
1.1
This standard applies to uniforms for Federal Public Service Firefighters.
1.2
The attention of users of this standard is drawn to Notes, par. 7.1 for
information on construction when uniforms are purchased privately.
User Selection Guide to CSA Standard CAN/CSA-A440-M90, Windows
This User Selection Guide is designed to accompany CSA Standard
A440, Windows, to assist specifiers, manufacturers, and general
users. Clause numbers in this Publication correspond to the
appropriate Clauses in CSA Standard A440.
Diagnostic Imaging and Radiation Therapy Equipment
1. Scope
1.1
This Standard applies to diagnostic imaging and radiation therapy equipment
designed to be
(a) installed and used in accordance with the Canadian Electrical Code, Part i
while connected to supply circuits with nominal system voltages of 750 V and
less; and
(b) battery powered, insofar as the requirements are applicable.
1.2
This Standard applies to
(a) diagnostic imaging…
Audit Checklist and Test Pack for Use with CAN/CSA-C22.2 No.231 Series-M89 CSA Safety Requirements ...
Preface
This Special Publication was prepared using the requirements in CAN/CSA-C22.2 No. 231 Series-M89, CSA Safety Requirements for Electrical and Electronic Measuring and Test Equipment.
It provides users with a checklist and testpack to determine if they comply with the requirements of CAN/CSA-C22.2 No. 231 Series-M89. The Clause numbering used in this publication parallels th at in…
