1 Scope
1.1
This performance Standard applies to circular precast concrete pipe, manhole (maintenance hole)
sections, and accessories intended for
(a) use as sewer pipe for the conveyance of sewage, industrial wastes, and storm water; and
(b) the construction of culverts.
1.2
This Standard describes the following procedures for testing circular precast concrete pipe, manhole
sections, and…
1 Scope
1.1
This Standard specifies minimum requirements for masonry materials and masonry construction.
Notes:
1) Requirements for structural design of masonry are specified in CSA S304.
2) If a requirement specified in Part 9 of the National Building Code of Canada differs from a requirement
specified in this Standard, the requirement specified in this Standard should be followed.
3) General…
1 Scope
1.1 General
This Standard specifies requirements, in accordance with the National Building Code of Canada, for the design and strength evaluation of
a)
structures of reinforced and prestressed concrete;
b)
plain concrete elements; and
c)
special structures such as parking structures, arches, tanks, reservoirs, bins and silos, towers, water towers, blast-resistant structures, and…
1.1
This Standard applies to motor-operated liquid pump units for use in nonhazardous, indoor, outdoor
(exposed), and submerged locations and designed to be used in accordance with the Rules of the
Canadian Electrical Code, Part I.
1.2
This Standard applies to
a) pumps for either permanent or cord-connection to the source of supply;
b) cord- and plug-connected pumps; and
c) component-type…
Power consumption of small network equipment (SNE)
1.1
This Standard specifies the test method for measuring and reporting the power consumption of small
network equipment.
Note: This Standard is technology neutral.
1.2
The following products are not covered by this Standard:
a) network equipment capable of accepting interchangeable modules, such as line cards or additional
power supplies;
b) network equipment with one or more network ports using…
1.1
This Standard applies to newly produced gas-fired outdoor infrared patio heaters (see Clause 3,
Definitions) hereinafter referred to as heaters or appliances, constructed entirely of new, unused parts
and materials.
Patio heaters are for use with:
a) natural gas; and
b) liquefied petroleum (propane) gases.
1.2
The heaters covered by this Standard are intended for installation in and…
Gas hose connectors for portable outdoor gas-fired appliances
1.1
This Standard applies to gas hose connectors (See Clause 3 Definitions), hereinafter referred to as
connectors. They are conduits for conveying gas and depend for gas-tightness on the wall structure of
the hose material. Such connectors shall be:
a) newly produced and constructed entirely of new, unused parts and materials; and
b) equipped with a fitting at each end provided with…
Standard for energy performance compliance, verification, and ratings of fuel-burning appliances and...
1.1
This Standard specifies criteria and methods to establish and verify the energy performance ratings for
fuel-burning appliances and equipment. This Standard includes procedures for sampling, analysis of test
results, and reporting.
1.2
This Standard applies , but is not limited, to the fuel-burning appliances listed in Table 1 and described in
Clause 14 that are tested in accordance…
1 Scope and application
1.1 General
This Standard provides rules and requirements for the design, fabrication, and erection of steel
structures. The design is based on limit states. The term “steel structures” refers to structural members
and frames that consist primarily of structural steel components, including the detail parts, welds, bolts,
or other fasteners required in fabrication and…
Industrial process control systems - Guideline for evaluating process control systems - Part 1: Spec...
IEC TS 62603-1:2014 describes methods and provides guidance for the evaluation of Process Control Systems (PCS) during the phase of selection between different proposals. The methods of evaluation proposed in this technical specification are intended for use mainly by users, engineering companies, or independent test laboratories, to verify manufacturers' proposals during the tender (as…
