Rechercher

This document specifies test methods for assessing the resistance of footwear to cutting by hand-held chainsaws. This document is applicable only to footwear with integral protection.

This document specifies the test rig for assessing the resistance to cutting of protective clothing, footwear and gloves by hand-held chainsaws. It also describes the calibration procedure.

This document specifies basic requirements for the design, layout and application of boom accessories, referred to as auxiliary equipment for the purpose of this document. This document does not purport to address all safety concerns, if any, associated with its use. However, it is the responsibility of the user of this document to establish the appropriate safety and health procedures, and to…

IEC/ASTM 62885-6:2018 is applicable for measurements of the performance of wet hard floor cleaning appliances for household use in or under conditions similar to those in households. In the case of appliances with combined functionality, this document only addresses the wet cleaning functionality. The purpose of this document is to specify essential performance characteristics of wet hard floor…

The purpose of this document is to provide guidance for developers of visual external communication systems for automated vehicles (AV), particularly Automated Driving System ? Dedicated Vehicles (ADS-DV), as defined by SAE J3016. The main objective of this document is to propose how ADS-DVs could communicate with other road users via an external communication system. It discusses the…

This document specifies a method of testing the continuous wave (cw) laser resistance of the shaft of a tracheal tube and the cuff regions including the inflation system of tracheal tubes designed to resist ignition by a laser. NOTE 1 When interpreting these results, the attention of the user is drawn to the fact that the direct applicability of the results of this test method to the clinical…

This document identifies the information required to determine the relationship between the position of a remotely sensed pixel in image coordinates and its geoposition. It supports exploitation of remotely sensed images. It defines the metadata to be distributed with the image to enable user determination of geographic position from the observations. This document specifies several ways in which…

IEC TR 63079:2017+A1:2018 gives recommendations for and guidance on the design, planning, installation, testing, operation and maintenance of a hearing-loop system (HLS) intended for communicating speech, music and/or other signals. It is mainly concerned with HLS for hearing enhancement, in which the signals are communicated to users of hearing aids equipped with magnetic pick-up coils. This…

1 Scope 1.1 This Standard sets out requirements for the selection, use, and care of respirators and for the administration of an effective respiratory protection program in the workplace. 1.2 This Standard is applicable to the selection, use, and care of respirators for non-emergency and emergency situations. 1.3 This Standard is not intended to address the selection of a) respirators for…

1 Scope 1.1 This Standard describes methods for determining the occupational noise exposure level of workers (Lex,T) using sampling techniques. Lex,T represents the long-term noise exposure of workers and is calculated from measurements of Leq,t (3 dB exchange rate) in the workplace. Notes: 1) The methods in this Standard are based on established definitions, units, instrumentation, and…