Road vehicles — Local Interconnect Network (LIN) — Part 4: Electrical physical layer (EPL) specifica...
This document specifies the 12 V and 24 V electrical physical layers (EPL) of the LIN communications system.
The electrical physical layer for LIN is designed for low-cost networks with bit rates up to 20 kbit/s to connect automotive electronic control units (ECUs). The medium that is used is a single wire for each receiver and transmitter with reference to ground.
Annex A provides…
Household and similar electrical appliances - Test code for the determination of airborne acoustical...
IEC 60704-2-3:2025 applies to single unit electric dishwashers for household and similar use, with or without automatic programme control, for cold and/or warm water supply, for detachable or permanent connection to water supply or sewage systems, intended for placing on the floor against a wall, for building-in or placing under a counter, a kitchen worktop or under a sink, for wall-mounting or…
Oil and gas industries including lower carbon energy — Pipeline transportation systems — Requirement...
This document presents assessment requirements and associated guidance for extending the service life of a pipeline system, as defined in ISO 13623, beyond its specified design life. It applies to both onshore and offshore rigid metallic pipelines and risers [including steel catenary risers (SCRs)].
This document is not directly applicable to the following:
— flexible pipelines;
— …
Le présent document fournit des lignes directrices sur la manière d'évaluer la faisabilité d'une prolongation de la durée de vie d'un réseau de conduites, tel qu'il est défini dans la norme ISO 13623, au-delà de sa durée de vie de conception spécifiée. Les stations de pompage, les postes de compression, les stations de réduction de pression et les dépôts ne sont pas…
Intelligent transport systems — Remote support for low speed automated driving systems (RS-LSADS) — ...
This document describes remote support provided to LSADS operated at Level 4 automation on predefined routes by a remotely located human in order to facilitate safe trip continuation. "Remote support" refers to the provision of information, or temporary performance of the dynamic driving task (DDT), and remote monitoring required for these functions.
This document is applicable to RS-…
Appareils audio, vidéo et matériel de traitement de l'information - Essais individuels de série...
L'IEC 62911:2025 définit des procédures d'essai destinées à être utilisées en cours ou en fin de fabrication d'appareils complets, de sous-ensembles ou de composants conformes à l'IEC 62368-1 et alimentés par un réseau d’alimentation en courant alternatif ou par un réseau d’alimentation en courant continu, afin de détecter des défaillances de fabrication et des tolérances…
Energy audits — Part 2: Guidance for conducting an energy audit using ISO 50002-1 in buildings
This document gives guidance on how to apply ISO 50002-1 to carry out energy audits of a building or group of buildings (new or existing). It is intended to be used in conjunction with, and is supplementary to, ISO 50002-1.
This document does not apply to other areas such as process audits (see ISO 50002-3), specific energy systems (e.g. compressed air) or transport.
This document is applicable…
Energy audits — Part 1: General requirements with guidance for use
This document specifies:
— the principles of carrying out energy audits;
— the process requirements for carrying out an energy audit in relation to energy performance;
— the roles and responsibilities of the organization and the energy auditor;
— deliverables for energy audits.
It gives guidance on determining and/or evaluating the competence of the energy auditor.
This document…
Plastics piping systems for the supply of gaseous fuels — Unplasticized polyamide (PA-U) piping syst...
This document specifies the characteristics of valves made from unplasticized polyamide (PA-U) in accordance with ISO 16486-1, intended to be buried and used for the supply of gaseous fuels.
NOTE 1 For the purpose of this document the term gaseous fuels include for example natural gas, methane, butane, propane, hydrogen, manufactured gas, biogas, and mixtures of these gases. Additional…
This document provides principles, requirements and guidance for performing an environmental techno-economic assessment (eTEA). eTEAs provide economic analyses combined with an assessment of environmental impacts.
This document specifies requirements for documenting the results, underlying assumptions, parameters and methodologies used in an eTEA.
This document is applicable to process systems of…
