Earth-moving machinery — Functional safety — Part 4: Design and evaluation of software and data tran...
This document specifies general principles for software development and signal transmission requirements of safety-related parts of machine-control systems (MCS) in earth-moving machinery (EMM) and its equipment, as defined in ISO 6165. In addition, this document addresses the significant hazards as defined in ISO 12100 related to the software embedded within the machine control system. The…
Earth-moving machinery — Functional safety — Part 1: Methodology to determine safety-related parts o...
This document provides a methodology for the determination of performance levels required for earth moving machinery (EMM) as defined in ISO 6165.
A Machine Control System Safety Analysis (MCSSA) determines the amount of risk reduction of hazards associated with control systems, required for Safety Control Systems (SCS). This reduction is quantified by the Machine Performance Level (MPL), the…
Determination of flash point — Pensky-Martens closed cup method
ISO 2719:2016 describes three procedures, A, B and C, using the Pensky-Martens closed cup tester, for determining the flash point of combustible liquids, liquids with suspended solids, liquids that tend to form a surface film under the test conditions, biodiesel and other liquids in the temperature range of 40 °C to 370 °C.
CAUTION - For certain mixtures no flash point, as defined, is observed;…
Polyethylene (PE) materials for piping systems — Determination of strain hardening modulus in relati...
ISO 18488:2015 specifies a method for the determination of the strain hardening modulus which is used as a measure for the resistance to slow crack growth of polyethylene.
The strain hardening modulus is obtained from stress-strain curves on compression moulded samples. This International Standard describes how such measurement is performed and how the strain hardening modulus shall be determined…
Jewellery and precious metals — Determination of silver — ICP-OES method using an internal standard ...
This document specifies an analytical method for the determination of silver on a material considered homogeneous. The silver content of the samples lies preferably between 50 ‰ (parts per thousand) and 990 ‰ (parts per thousand). Fineness above 999,0 ‰ can be determined using a spectroscopy method by difference (e.g. ISO 15096).
NOTE Lower contents of silver can be analyzed with this method.
Health informatics - Information security controls in health based on ISO/IEC 27002
ISO 27799:2016 gives guidelines for organizational information security standards and information security management practices including the selection, implementation and management of controls taking into consideration the organization's information security risk environment(s).
It defines guidelines to support the interpretation and implementation in health informatics of ISO/IEC 27002…
