Rechercher

This document defines testing coupons and methods for the evaluation of the compression strength of AM lattice designs. The standardized test coupons will accommodate the application of a variety of lattice designs, while standardizing the evaluation method. This document is generally intended to be used in validation or verification activities for an additively manufactured component that…

This document addresses good clinical practice for the design, conduct, recording and reporting of clinical investigations carried out in human subjects to assess the clinical performance or effectiveness and safety of medical devices. For post-market clinical investigations, the principles set forth in this document are intended to be followed as far as relevant, considering the nature of the…

This document describes the use of modal acoustic emission (MAE) testing during periodic inspection and testing of hoop wrapped and fully wrapped composite transportable gas cylinders and tubes, with aluminium-alloy, steel or non-metallic liners construction, intended for compressed and liquefied gases under pressure. This document addresses the periodic inspection and testing of composite…

This document specifies the delivery conditions for high manganese austenitic steel in forms of hot rolled or cold rolled plates, sheets,  and coils for low temperature purposes. This document does not purport to address all the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine…

This part of 81346 International Standard, published jointly by IEC and ISO, provides, in combination with IEC 81346-1 and IEC 81346-2, rules and recommendations on the structuring of processes and basic activities. It provides the tools to handle the information on processes in the area of technical products and equipment. It also provides classification of basic activities to enable a model of…

ISO 10110-5:2015 specifies the presentation of design and functional requirements for optical elements and systems in technical drawings used for manufacturing and inspection. ISO 10110-5:2015 specifies rules for indicating the tolerance for surface form deviation. NOTE The terminology of interferometry employing the unit "fringe spacings" is widely used for the specification of…

ISO/SAE 1979-3 is intended to satisfy the data reporting requirements of regulations in the United States and Europe, and any other market that may adopt similar requirements in the future. This document specifies diagnostic services required to be supported by motor vehicles and external test equipment for diagnostic purposes which pertain to Zero Emission Vehicle (ZEV) propulsion related data…

This International Standard gives competency requirements applicable for the selection, training, assessment and verification of crane drivers (operators), slingers, signallers and their assessors. This International Standard does not cover additional competency requirements needed for special operations, e.g. man-lifting, pile-driving or pile-pulling. NOTE 1 Responsibilities for the performance…

This document defines requirements for collision warning (CWS) and collision avoidance systems (CAS) that address other forms of motion than forward/reverse and rotation for: — earth-moving machinery as defined in ISO 6165, — mobile underground mining machinery as defined in ISO 19296, rock drill rigs as defined in ISO 22935-5, and — road construction machinery as defined in ISO 22242. Clauses 5…

IEC 60601-1:2005+A1:2012, 1.1 is replaced by: This document applies to the basic safety and essential performance of medical supply units, hereafter also referred to as ME equipment. This document applies to medical supply units manufactured within a factory or assembled on site, including cabinetry and other enclosures, which incorporate patient care services. NOTE 1 A party that assembles on…