Rechercher

Note: In order to maintain a consistent clause number/subject matter relationship throughout this Standard, some numbers have been purposely omitted. 1. Scope 1.1 This Standard applies to control and protective devices, and accessory devices rated at not more than 1500 V, for starting, stopping, regulating, controlling, or protecting electric motors, generators, heating apparatus, or…

1. Scope 1.1 This Standard provides methods for evaluating the force, deflection, and energy-absorption characteristics of rollover protective structures (ROPS) under static loading. This Standard applies to the testing of ROPS on industrial tractors, motor graders, prime movers, skidders, tracked dozers, tracked loaders, wheeled dozers, wheeled loaders, backhoe loaders, rigid-frame dumpers,…

This International Standard specifies the physical characteristics of identification cards including card materials, construction, characteristics, and dimensions for three sizes of card. ISO/IEC 10373 specifies the test procedures used to check cards against the parameters specified in this International Standard. This International Standard specifies the requirements for cards used for…

This International Standard specifies the physical characteristics of identification cards including card materials, construction, characteristics, and dimensions for three sizes of card.  ISO/IEC 10373 specifies the test procedures used to check cards against the parameters specified in this International Standard.  This International Standard specifies the requirements for cards used for…

Introduction The Model Code for the Protection of Personal Information being developed under the auspices of the Canadian Standards Association (CSA) has the potential to advance the cause of personal-data protection in Canada. No other country has attempted to negotiate and establish on a voluntary basis a general minimum standard for privacy protection in its private sector. As an…

1. Purpose and Scope 1.1 This method describes a procedure for conditioning most types of geosynthetics to a temperature and to a moisture equilibrium with a standard atmosphere. This method is not recommended for geosynthetic clay liners. 1.2 The standard atmosphere is defined as air maintained at a temperature of 23 ± 2°C and a relative humidity of 60…

1. Scope 1.1 This test method covers the determination of the drop melting point of petroleum wax. It is used primarily for petrolatums and other microcrystalline was. NOTE 1 - Additional methods used for petroleum waxes are Test Method D 87 and Test Method D 938. Results obtained may differ, depending on the method used. For pharmaceutical petrolatum, Test Method D 127 usually is…

1 SCOPe This Recommended Practice covers basic provisions for HEPA (high efficiency particulate air) and ULPA (ultra-low penetration air) filter units as a basis for agreement between buyers and sellers. Filters that meet the requirements of this Recommended Practice (RP) are suitable for use in clean air devices and cleanrooms that come within the scope of Federal Standard 209 and for…

1.1 SCOPE 1.1.1 This standard applies to newly produced Type 1 clothes dryers (see Part IV, Definitions), hereinafter referred to as dryers, constructed entirely of new, unused parts and materials: a. For use with natural gas, b. For use with manufactured gas, c. For use with mixed gas, d. For use with liquefied petroleum gases…

1. Scope 1.1 This Standard describes requirements and test methods for materials, dimensions, quality of work, pipe stiffness, quality control, joining systems, and marking for SDR 28, 35, and 41 Type PSM PVC sewer pipe and fittings. Note: Industrial waste disposal lines should be installed only with specific approval of the regulatory authority, since chemicals not commonly found in…