Rechercher

1 Scope 1.1 The objective of this Standard is to establish minimum criteria for effective emergency preparedness and response. 1.2 This Standard applies to all organizations (as defined in Clause 3.1) that may be affected by natural, technological, and human events that could have a detrimental impact on, among other things, the following: a) the health and safety of persons in the…

This National Standard of Canada is equivalent to International Standard ISO 5007:2003 (second edition, 2003-03-15). 1 Scope This International Standard specifies, in accordance with ISO 10326-1, a laboratory method for measuring and evaluating the effectiveness of the suspension of operator seats on agricultural wheeled tractors. It also specifies acceptance criteria based on the test results…

ISO 4628-2:2003 describes a method for assessing the degree of blistering of coatings by comparison with pictorial standards. NOTE The pictorial standards have been adopted from ASTM D 714, Standard Test Method for Evaluating Degree of Blistering of Paints. The correlation between the ISO and ASTM rating systems is shown in an annex.

ISO 4628-3:2003 describes a method for assessing the degree of rusting of coatings by comparison with pictorial standards. The pictorial standards provided in this part of ISO 4628 show coated steel surfaces which have deteriorated to different degrees by a combination of rust broken through the coating and visible underrust. NOTE 1 The pictorial standards have been selected from the European…

This National Standard of Canada is equivalent to International Standard ISO 17510-2:2003 (first edition, 2003-01-15). 1 Scope This part of the European Standard specifies requirements for masks and accessories which are required to connect the patient connection port to a sleep apnoea breathing therapy device and the mask to a patient, and are used for the application of sleep apnoea…

This National Standard of Canada is equivalent to International Standard CEI/IEC 61000-4-7:2002 (second edition, 2002-08). 1 Scope This part of IEC 61000 is applicable to instrumentation intended for measuring spectral components in the frequency range up to 9 kHz which are superimposed on the fundamental of the power supply systems at 50 Hz and 60 Hz. For practical considerations, this…

1 Scope 1.1 This Standard applies to (a) steam sterilizers that (i) have a chamber volume of 42.5 L (1.5 ft3) or greater; and (ii) are intended for use in health care facilities; (b) emergency (flash) sterilizers; and (c) washer-disinfectors (when used in sterilizer mode). Notes: (1) In this Standard, <sterilizer> is used as a blanket term for the three types of…

ISO 7235:2003 specifies methods for determining the insertion loss, in frequency bands, of ducted silencers with and without airflow,the sound power level, in frequency bands, of the flow noise (or regenerated sound) generated by ducted silencers,the total pressure loss of silencers with airflow, andthe transmission loss, in frequency bands, of air-terminal units. The measurement procedures are…

B45.0-02 Exigences générales relatives aux appareils sanitaires 1. Domaine d'application 1.1 Cette norme vise les appareils sanitaires suivants: a) baignoires; b) éviers de cuisine et de bar; c) lavabos; d) cuves à lessive; e) cabines et bacs de douche; f) fontaines et refroidisseurs; g) toilettes; h) bidets; i) urinoirs; j) toilettes sans recirculation et réservoirs de…

1. Scope 1.1 This Standard covers welding requirements for carbon and low-alloy welded steel construction, with the exception of those types listed in Clause 1.2. Requirements that are essentially common to all such structures are covered in Clauses 1 to 10, while provisions applying specifically to statically loaded structures and to cyclically loaded structures are included in Clauses 11 and…