Rechercher

This National Standard of Canada is equivalent to International Standard ISO/IEC 15018:2004. 1 Scope This International Standard specifies generic cabling for homes. A home may contain one or more buildings or may be within a building that contains more than one home. This standard specifies a generic cabling for three groups of applications: . Information and Communications Technologies (…

This National Standard of Canada is equivalent to International Standard ISO/IEC 7816-6:2004. 1 Scope This part of ISO/IEC 7816 specifies a registration procedure for application providers, and establishes the authorities and procedures to ensure and optimize the reliability of this registration. NOTE 1 ISO/IEC 7816-4 defines the structures of registered application provider identifiers (RIDs),…

CSA Preface Standards development within the Information Technology sector is harmonized with international standards development. Through the CSA Technical Committee on Information Technology (TCIT), Canadians serve as the Canadian Advisory Committee (CAC) on ISO/IEC Joint Technical Committee 1 on Information Technology (ISO/IEC JTC1) for the Standards Council of Canada (SCC), the ISO member…

This National Standard of Canada is equivalent to International Standard ISO/IEC 8825-5:2004. 1 Scope This Recommendation | International Standard specifies a mapping from any XSD Schema into an ASN.1 schema. The ASN.1 schema supports the same semantics and validates the same set of XML documents. This Recommendation | International Standard specifies the final XER encoding instructions…

ISO 22853:2005 specifies the XML application MSML (Maritime Safety Markup Language). MSML is a language for structuring information and the goal is to create an open standard that can be used generally in the maritime sector. MSML is implemented using XML Schema, which is contained in a separate document that could be used at validation. The first purpose of MSML is to make it possible to record…

1 Scope 1.1 This Standard covers groove-type mechanical pipe couplings for liquid and gas pressure pipes up to and including NPS-42 and shoulder-type mechanical pipe couplings for liquid and gas pressure pipes up to and including NPS-60. 1.2 This Standard includes minimum requirements for materials, chemical properties, physical properties, pipe groove and shoulder dimensions, finishes,…

1 Scope 1.1 This Standard covers asphalt saturated organic roofing felt, with perforations, to be used with roofing asphalts conforming to CSA A123.4 in the construction of built-up roofing membranes, without perforations, applied as an underlayment beneath asphalt shingles, woods shakes and shingles, tiles, and other roof coverings. 1.2 The following types of roofing felts are addressed…

1.1 Scope Replace this clause of the RD with the following: 1.1.1 Equipment covered by this Standard This Standard applies to UNINTERRUPTIBLE POWER SYSTEMS (UPS). The primary function of the UPS for this Standard is to ensure continuity of an alternating power source. The UNINTERRUPTIBLE POWER SYSTEM may also serve to improve the quality of the power source by keeping it within specified…

1 Scope 1.1 General This Standard covers wrought steel buttwelding fittings, including extruded headers and factory-produced bends, primarily intended for use in oil or gas pipeline systems. 1.2 Size, grade, and category 1.2.1 Size This Standard covers fittings in sizes from NPS 1/2 to NPS 60. (Refer to Table A.1.) 1.2.2 Grade For other than sour service, this Standard covers…

1 Scope 1.1 General This Standard covers wrought steel flanges primarily intended for use in oil or gas pipeline systems. 1.2 Size, grade, nominal pressure class, and category 1.2.1 Size This Standard covers flanges in sizes from NPS 1/2 to NPS 60. (See Table A.1.) 1.2.2 Grade For other than sour service, this Standard covers flanges from Grade 248 to Grade 550. For sour service…