Rechercher

Domaine d'application 1.1 Cette norme énonce les modes opératoires et les exigences de tenue pour lampes standards à culot à vis dont la tension nominale se situe au moins partiellement entre 100 et 130 V. 1.2 Cette norme n'énonce pas d'exigences visant les luminaires utilisés avec des lampes standards. 1.3 Dans cette norme, le terme «doit» indique une exigence, c'est-à-dire…

Scope 1.1 This Standard applies to common types of portable ladders and includes design and performance-related requirements and tests. 1.2 Ladders covered by this Standard are intended for use by only one person at a time under normal conditions of usage, with the exception of trestle ladders, which are designed for use by two persons at the same time. 1.3 This Standard does not…

Scope 1.1 This Standard provides definitions, classifications, and a method for determining calculated daily energy consumption (CDEC) values and specifies minimum energy efficiency requirements for refrigerated display cabinets. 1.2 This Standard applies to the refrigerated display cabinets (with or without an integral refrigerated storage cabinet) that are described in Clause 4 and intended…

1 Scope 1.1 This Standard specifies the technical requirements for the design, procurement, fabrication, installation, modification, repair, replacement, testing, examination, and inspection of, and other work related to, pressure-retaining systems, components, and supports over the service life of a CANDU nuclear power plant. 1.2 This Standard applies to all pressure-retaining systems,…

IEC 60294:2012 applies to cylindrical capacitors and resistors for use in electronic equipment. This standard gives methods for measurement of the body length and for checking the excessive protective coating extending onto the wire terminations of components with axial wire terminations. It further provides a method for checking the overall body diameter of cylindrical components with axial wire…

IEC 60544-2:2012 specifies the controls maintained over the exposure conditions during and after the irradiation of insulating materials with ionizing radiation prior to the determination of radiation-induced changes in physical or chemical properties. This standard specifies a number of potentially significant irradiation conditions as well as various parameters which can influence the radiation…

This standard specifies the characteristics that biomethane shall have at the injection point in the natural gas distribution or transmission system to ensure its compatibility with the characteristics of the natural gas present in the system into which it is injected. This standard applies to biomethane produced from biogas derived from anaerobic decomposition, no matter the source of the…

1 Scope 1.1 This Standard applies to products and component devices where the electronics technology handles the operational logic including the safety features. This Standard applies to the following configurations: (a) safety control function(s) implemented in hardware only; and (b) safety control function(s) implemented in some combinations of hardware and software. Note: Clauses that…

1 Scope [Add the following paragraphs and note] The object of this Standard is to specify general electrical safety requirements for certain products. The requirements of this Standard apply to a specific end-use product when it is explicitly referred to by that product Standard. Each individual product Standard may supplement, modify, or omit a general rule in the Part 1 Standard to provide the…

201.1.1 * Scope Replacement: This particular standard applies to the BASIC SAFETY and ESSENTIAL PERFORMANCE of ELECTROCARDIOGRAPHS as defined in 201.3.63 intended by themselves or as a part of an ME SYSTEM, for the production of ECG REPORTS for diagnostic purposes, hereinafter referred to as ME EQUIPMENT. Not included within the scope of this particular standard are: a) the part of ME EQUIPMENT…