Rechercher

This Recommendation | Technical Report provides: a) the description of a means to permit a protocol to be identified; b) a record of the structure and allowable ranges of protocol identifier(s) which can be assigned by ITU-T, ISO/IEC and other authorities; c) a record of the values of protocol identifiers used by OSI Network layer protocols and non-OSI protocols occupying a similar position: in…

This National Standard of Canada is based on International Standard CEI/IEC 71-1:1993 1 Scope This part of International Standard IEC 71 applies to three-phase a.c. systems having a highest voltage for equipment above 1 kV. It specifies the procedure for the selection of the standard withstand voltages for the phase-to-earth, phase-to-phase and longitudinal insulation of the equipment…

1. Scope This International Standard is applicable to string insulator units of ceramic material or glass for use on d.c. overhead power lines with a nominal voltage greater than 1 000 V. It is not applicable to composite insulators. The application of this standard to insulators for use in other situations under d.c. voltage will be left to the relevant technical committees. This…

Purpose of Standard This National Standard of Canada has been reviewed and adopted for Canadian use by the CGSB Committee on Metrology - Terminology and OIML. It is identical in content and in layout, without editorial changes, with the ISO document, International vocabulary of basic and general terms in metrology, published in 1993.

Preface This is the first edition of CSA Special Publication PLUS 9014, ISO 9000 Interpretations. It is a compendium of interpretations given on the ISO 9000 family of Standards and approved by the CSA Technical Committee on Quality Management (TC on QM). The ISO 9000 family of Standards was developed by quality experts from around the world, under the auspices of the Internationa l…

This National Standard of Canada is equivalent to International Standard CEI/IEC 1000-2-1:1990. 1 Scope This section of IEC 1000-2 is concerned with conducted disturbances in the frequency range up to 10 kHz with an extension for mains signalling systems. Separate sections give numerical compatibility levels for different system voltage levels. This section does not deal with the application…

This National Standard of Canada is based on International Standard CEI/IEC 1000-2-2:1990. 1 Scope This section of IEC 1000-2 is concerned with conducted disturbances in the frequency range up to 10 kHz with an extension for mains signalling systems. This section gives numerical compatibility levels for low voltage a.c. distribution systems with a nominal voltage up to 347 V, single-…

Introduction - The Purpose of This Workbook The Publication CAN/CSA-Q830, A Model Code for the Protection of Personal Information, referred to as the CSA Code, (a) provides the principles for the management of personal information; (b) specifies the minimum requirements for the adequate protection of personal information held by participating organizations; (c) makes the Canadian…

The international community has decided to make this standard available only in the English language version. It has been adopted as a National Standard of Canada on this basis. This National Standard of Canada is equivalent to International Standard ISO/IEC TR 9577:1993. 1 Scope This Technical Report provides a) the description of a means to permit a protocol to be…

COMMITTEE SCOPE The CGSB PTM Committee is responsible for developing, modifying, updating and deleting test methods relating to petroleum products such as fuels, lubricants, industrial oils and greases, and associated products. With the guidance of the CGSB Petroleum Coordinating Committee regarding priorities, the CGSB PTm Committee will develop and evaluate test procedures requested by…