Rechercher

This clause of Part 1* is replaced by the following. * For the purposes of this Standard, the term “Part 1” means “CAN/CSA-C22.2 No. 60335-1 (second edition)/ UL 60335-1 (sixth edition)”. The machines covered in this Standard are intended for floors with an artificial surface and used for the following applications: a) sweeping; b) scrubbing; c) wet or dry pickup; d) polishing; e) application of…

ISO 21307:2017 establishes general principles regarding the procedure used in the construction and quality assessment of butt fusion jointing of polyethylene (PE) piping system components specified in accordance with relevant ISO standards. These components are installed in accordance with the relevant codes of practice, national regulations or industry guidance. Specifically, this document…

The purpose of ISO/TS 18864:2017 is to define objective, reliable and reproducible quality metrics for detailed clinical models (DCM). ISO/TS 18864:2017 specifies the principal metrics which are necessary and sufficient to evaluate DCMs. The intended audiences of this document are: - DCM developers, all users of information represented using DCMs, and evaluators of DCM quality; -…

This is a standard for short-range, wireless communication in the vicinity of, or inside, a human body (but not limited to humans). It uses existing industrial scientific medical (ISM) bands as well as frequency bands approved by national medical and/or regulatory authorities. Support for quality of service (QoS), extremely low power, and data rates up to 10 Mbps is required while simultaneously…

This is a standard for short-range, wireless communication in the vicinity of, or inside, a human body (but not limited to humans). It uses existing industrial scientific medical (ISM) bands as well as frequency bands approved by national medical and/or regulatory authorities. Support for quality of service (QoS), extremely low power, and data rates up to 10 Mbps is required while simultaneously…

This National Standard of Canada states the minimum requirements and test methods for performance of protective workwear worn for protection against unplanned exposure to hydrocarbon flash fire and optionally steam and hot fluids. This standard applies to newly manufactured (ie. unworn) protective workwear that individually, or as a component of an ensemble, covers the body from the neckline…

1.1 This Standard applies to newly produced Type 1 clothes dryers (see Clause 3, Definitions), hereinafter referred to as dryers, constructed entirely of new, unused parts and materials: a) for use with natural gas; b) for use with manufactured gas; c) for use with mixed gas; d) for use with propane gas; e) for use with LP gas-air mixtures; and f) for mobile home installation (see…

1.1 This Standard applies to newly produced, direct-fired construction heaters, hereinafter referred to as heaters or appliances, constructed entirely of new, unused parts and materials and primarily intended for temporary use in heating buildings or structures under construction, alteration, or repair. All the products of combustion generated by the heater are released into the area being…

This clause of Part 1 is replaced by the following. This International Standard deals with the safety of sealed (hermetic and semi-hermetic type) MOTORCOMPRESSORS, their protection and control systems, if any, which are intended for use in equipment for household and similar purposes and which conform with the standards applicable to such equipment. It applies to MOTOR-COMPRESSORS tested…

1.1 This Standard addresses issues related to the safety of human allogeneic and autologous cells of lymphohematopoietic origin used for transplantation and includes quality system requirements. This Standard includes aspects of safety for potential and actual donors and recipients, personnel, and others who might be exposed to or affected by the transplant of lymphohematopoietic cells. The…