Rechercher

This document specifies the characteristics and production methods of X and gamma reference radiation for calibrating protection-level dosemeters and doserate meters with respect to the phantom related operational quantities of the International Commission on Radiation Units and Measurements (ICRU)[5]. The lowest air kerma rate for which this standard is applicable is 1 µGy h?1. Below this air…

This document gives guidelines for determining the average surface density over a measured area of anodic oxide or of a coating deposited autocatalytically, mechanically, by chemical conversion, by electrodeposition, by hot dip galvanizing and by chemical or physical vapour deposition using gravimetric and other chemical analysis procedures that have attained some degree of national or…

1 Scope 1.1 These requirements cover products (e.g. repeater, transmitter, receiver, signal booster components, remote annunciators and operational consoles, power supply, and battery charging system components) used for in-building 2-way emergency radio communication enhancement systems installed in a location to improve wireless communication at that location. 1.2 In the United States –…

1 Domaine d’application 1.1 Les présentes exigences concernent les produits (répéteurs, émetteurs, récepteurs, amplificateurs de signaux, annonciateurs à distance et consoles d’exploitation, sources d’alimentation et composants de système de charge de batterie) utilisés dans les systèmes d’amélioration de la radiocommunication bidirectionnelle intérieure d’urgence en vue d’améliorer la…

1 Scope This National Standard of Canada defines equipment requirements, performance criteria, and operating and testing procedures for the implementation of a vapour control system (VCS) in gasoline distribution networks including terminals, bulk plants, service stations and cargo tanks, commonly known as Stage I (see Figure 1 for a schematic representation). This standard does not include…

1 Scope This International Standard specifies the loading and strength requirements of overhead lines derived from reliability-based design principles. These requirements apply to lines 45 kV and above, but can also be applied to lines with a lower nominal voltage. This document also provides a framework for the preparation of national standards dealing with overhead transmission lines,…

This document defines the requirements of printing workflows and evaluation methods for their tone and colour reproduction. It applies to any printing process using any colourant, such as CMYK, CMYK with spot, non-CMYK, spot only or multicolour. This document refers and points to international or national standards and can be used to define, evaluate and audit any printing workflow in whole or…

Preface This is the common ANCE, CSA, and UL standard for electrical rigid metal conduit - aluminum, red brass, and stainless steel. It is the second edition of NMX-J-576-ANCE, the first edition of CSA C22.2 No. 45.2, and the second edition of UL 6A. This edition of UL 6A supersedes the previous edition published on July 21, 2000. 1 Scope 1.1 These requirements cover aluminum (ERMC-A)…

IEC 60335-2-8:2012+A1:2015+A2:2018 deals with the safety of electric shavers, hair clippers and similar appliances intended for household and similar purposes, their rated voltage being not more than 250 V. Examples of similar appliances are those used for manicure and pedicure. Appliances not intended for normal household use, but which nevertheless may be a source of danger to the public, such…

1 Scope 1.1 This Standard sets forth minimum design and construction requirements for fibre reinforced plastic, non-pressure tanks that are used for the underground storage of flammable and combustible liquids, such as: a) Petroleum products, including petroleum hydrocarbon fuels with low-biofuels blends, per specifications, and similar flammable or combustible liquid petroleum…