Rechercher

ISO 20077-1:2017 defines the concepts and the terms related to extended vehicles. ISO 20077-1:2017 presents general information regarding these vehicles, specifies the dedicated terminology and describes the interrelation with other standards related to extended vehicles. ISO 20077-1:2017 concerns: - road vehicles with four or more wheels designed and constructed primarily for the carriage…

ISO 21307:2017 establishes general principles regarding the procedure used in the construction and quality assessment of butt fusion jointing of polyethylene (PE) piping system components specified in accordance with relevant ISO standards. These components are installed in accordance with the relevant codes of practice, national regulations or industry guidance. Specifically, this document…

The purpose of ISO/TS 18864:2017 is to define objective, reliable and reproducible quality metrics for detailed clinical models (DCM). ISO/TS 18864:2017 specifies the principal metrics which are necessary and sufficient to evaluate DCMs. The intended audiences of this document are: - DCM developers, all users of information represented using DCMs, and evaluators of DCM quality; -…

This is a standard for short-range, wireless communication in the vicinity of, or inside, a human body (but not limited to humans). It uses existing industrial scientific medical (ISM) bands as well as frequency bands approved by national medical and/or regulatory authorities. Support for quality of service (QoS), extremely low power, and data rates up to 10 Mbps is required while simultaneously…

This is a standard for short-range, wireless communication in the vicinity of, or inside, a human body (but not limited to humans). It uses existing industrial scientific medical (ISM) bands as well as frequency bands approved by national medical and/or regulatory authorities. Support for quality of service (QoS), extremely low power, and data rates up to 10 Mbps is required while simultaneously…

This National Standard of Canada (NSC) addresses system design and installation requirements for radon mitigation in existing low-rise residential buildings (see 3.37). This standard provides diagnostic methods, design and installation instructions, and acceptable materials and product specifications, to maximize the radon reduction capacity of the system. This standard is specific to radon…

This National Standard of Canada states the minimum requirements and test methods for performance of protective workwear worn for protection against unplanned exposure to hydrocarbon flash fire and optionally steam and hot fluids. This standard applies to newly manufactured (ie. unworn) protective workwear that individually, or as a component of an ensemble, covers the body from the neckline…

1.1 This Standard applies to newly produced Type 1 clothes dryers (see Clause 3, Definitions), hereinafter referred to as dryers, constructed entirely of new, unused parts and materials: a) for use with natural gas; b) for use with manufactured gas; c) for use with mixed gas; d) for use with propane gas; e) for use with LP gas-air mixtures; and f) for mobile home installation (see…

1.1 This Standard applies to newly produced, direct-fired construction heaters, hereinafter referred to as heaters or appliances, constructed entirely of new, unused parts and materials and primarily intended for temporary use in heating buildings or structures under construction, alteration, or repair. All the products of combustion generated by the heater are released into the area being…

This clause of Part 1 is replaced by the following. This International Standard deals with the safety of sealed (hermetic and semi-hermetic type) MOTORCOMPRESSORS, their protection and control systems, if any, which are intended for use in equipment for household and similar purposes and which conform with the standards applicable to such equipment. It applies to MOTOR-COMPRESSORS tested…