Plugs and socket-outlets for domestic and similar general use. Standards.
Contains specification sheets for three groups of plugs and socket-outlets for domestic and similar general use:
Group A:American National Standards Institute (ANSI)
Group B:British Standards Institution (BSI)
Group C:International Commission on Rules for the Approval of Electrical Equipment (CEE)
This publication has the status of a technical report.
Indicating Pressure Gauges for Fire Protection Service
1.1
These requirements cover indicating pressure gauges of the elastic element type
for use with sprinkler or standpipe equipment for fire protection service. The
nominal sizes of gauges covered by these requirements are limited to 3-1/2 and
4-1/2 inches.
1.2
Requirements for the installation and use of the gauges covered by this Guide
are included in the Standards of the National Fire…
1.1
These requirements cover hydrants employed in piping systems supplying water
for fire-protection service.
1.2
Requirements for the installation and use of hydrants covered by these
requirements include, among others, the Standard of the National Fire
Protection Association for Outside Protection, NFPA 24.
Paints and varnishes — Notes for guidance on the conduct of natural weathering tests
Specifies the factors which need to be taken into consideration in the selection of methods for the exposure to natural weathering of paint films or systems for the purpose of evaluating their durability. A method is specified which is recommended for the use where no specialized requirements apply. Supplementary information shall be derived from the national standard or shall be the subject of…
Aircraft — Fire-resisting electrical cables — Methods of test
Specifies the tests suitable for establishing the compliance of cables with the performance requirements stated in ISO 2155. Is intended to serve as a basis for test specifications to be included in the relevant national standards when the Official Board of Inspection considers that existing tests are inadequate. The tests are classified in type tests only, type tests and routine productions…
Heat-resisting equipment wires for aircraft — Methods of test
This International Standard specifies the rest procedures suitable for establishing the compliance of wires with the performance requirements stated in ISO 2032. They are intended for use as a basis for specifying tests in the relevant national specifications when the national type approving authorities consider that existing tests are inadequate. The test procedures are classified in type tests…
Mechanical standardization of semiconductor devices. Part 1: Preparation of drawings of semiconducto...
Gives recommended practice for the preparation of drawings of semiconductor devices, drawings which indicate the space which should be allowed for devices in equipment together with other dimensional characteristics required to ensure mechanical interchangeability. These drawings represent the unification of the national standards and encourage the manufacturers of devices to comply with the…
Standards for plugs and socket-outlets for domestic and similar general use
Contains specification sheets for three groups of plugs and socket-outlets for domestic and similar general use:
Group A: American National Standards Institute (ANSI)
Group B: British Standards Institution (BSI)
Group C: International Commission on Rules for the Approval of Electrical Equipment (CEE)
This publication has the status of a technical report.
Clinical investigation of medical devices for human subjects — Good clinical practice
This document addresses good clinical practice for the design, conduct, recording and reporting of clinical investigations carried out in human subjects to assess the clinical performance or effectiveness and safety of medical devices.
For post-market clinical investigations, the principles set forth in this document are intended to be followed as far as relevant, considering the nature of the…
