Rechercher

IEC 62841-2-14:2015 applies to hand-held planners the rated voltage is not more than 250 V for single-phase a.c. or d.c. tools, and 480 V for three-phase a.c. tools. The rated input is not more than 3 700 W. The limits for the applicability of this standard for battery tools is given in Annex K. This standard deals with the hazards presented by tools which are encountered by all persons in the…

IEC 62841-2-14:2015 applies to hand-held planners the rated voltage is not more than 250 V for single-phase a.c. or d.c. tools, and 480 V for three-phase a.c. tools. The rated input is not more than 3 700 W. The limits for the applicability of this standard for battery tools is given in Annex K. This standard deals with the hazards presented by tools which are encountered by all persons in the…

ISO 18086:2015 is applicable to buried cathodically-protected pipeline that is influenced by AC traction systems and/or AC power lines. In the presence of AC interference, the protection criteria given in ISO 15589 1 are not sufficient to demonstrate that the steel is being protected against corrosion. ISO 18086:2015 provides limits, measurement procedures, mitigation measures, and information to…

ISO 18314-2:2015 specifies the Saunderson correction for different measurement geometries and the solutions of the Kubelka-Munk equation for hiding and transparent layers. It also specifies methods for the calculations of the tinting strength including the residual colour difference with different criteria and of the hiding power. The procedures for preparing the samples for these measurements…

1.1 This Standard covers the refurbishing of shop fabricated tanks built to nationally recognized Standards listed in Tank Eligibility Subsections 6.2 and 7.2. NOTE: In the context of this Standard, refurbishing refers to repairs to, and a limited set of modifications of, tanks using materials at least equivalent to those used in the original manufacture and does not include retrofit. Refer to…

1.1 The requirements in this standard cover sealed wire connector systems, including insulating caps, covers, resins, tubing, and tapes provided with, or for use with, specific wire connectors. These systems are intended for wet or damp locations, and other installations such as direct burial, below grade, or above grade where protected from direct exposure to sunlight. The wire connectors…

IEC 60335-2-89:2010+A1:2012+A2:2015 specifies safety requirements for electrically operated commercial refrigerating appliances that have an incorporated compressor or that are supplied in two units for assembly as a single appliance in accordance with the manufacturer's instructions (split system). Appliances that are within the scope of this standard are: - refrigerated display and…

ISO/TR 17185-3:2015 is to define high level general requirements of journey planning systems by standardizing use cases. This part of ISO 17185 defines basic requirements for implementing the journey planning system, from the viewpoint that the public transport users should be provided with convenient tool to make his or her journey more efficient ones. In order to realize the desirable journey…

ISO 29400:2015 provides comprehensive requirements and guidance for the planning and engineering of port and marine operations, encompassing all documents and works related to such port and marine operations, e.g. the design and analysis of the components, systems, equipment and procedures required to perform port and marine operations, as well as the methods or procedures developed to carry them…

1.1 Scope and references This Standard details mechanical, physical, and electrical requirements for a newly manufactured appliance that dispenses natural gas for vehicles directly into the vehicle natural gas fuel storage system, referred to as a residential fueling appliance (RFA). 1.2 These requirements apply to appliances for: a) natural gas only (see Clause 1.1); b) outdoor or indoor…