Rechercher

This National Standard of Canada is based on International Standard IEC 60745-1:2003, and is joint with UL 60745-1. 1 Scope 1.1 This International Standard deals with the safety of hand-held motor-operated or magnetically driven electric tools, the rated voltage of the tools being not more than 250 V for single-phase a.c. or d.c. tools, and 440 V for three-phase a.c. tools. So far as is…

This National Standard of Canada is equivalent to International Standard IEC 60745-2-9:2003, and is joint with UL 60745-2-9. 1 Scope This clause of Part 1 is applicable except as follows: 1.1 Addition: This standard applies to tappers.

This National Standard of Canada is based on International Standard IEC 60745-2-11:2003, and is joint with UL 60745-2-11. 1 Scope This clause of Part 1 is applicable, except as follows: 1.1 Addition: This standard applies to reciprocating saws. Tools covered by this standard include but are not limited to jigsaws and reciprocating saws (sabre saws).

This National Standard of Canada is based on International Standard IEC 60745-2-14:2003, and is joint with UL 60745-2-14. 1 Scope This clause of Part 1 is applicable except as follows: 1.1 Addition: This standard applies to planers.

This National Standard of Canada is based on International Standard IEC 60745-2-17:2003, and is joint with UL 60745-2-17. 1 Scope This clause of Part 1 is applicable except as follows: 1.1 Addition: This standard applies to routers and trimmers.

This National Standard of Canada is based on International Standard ISO 5359:2000 (second edition, 2000-11-01). Scope 1.1 This International Standard specifies requirements for low-pressure hose assemblies intended for use with the following medical gases: - oxygen; - nitrous oxide; - air for breathing; - helium; - carbon dioxide; - xenon; - specified mixtures of the gases listed above; - air…

This handbook has been developed to answer general questions common to all health care practices and personal services. - How do I process an instrument after I have used it on a patient or client? - What kind of disinfectant should I use? - What kind of sterilizer should I use and do I really need one? - How do I dispose of a contaminated article? - What should I do with needles and other…

This National Standard of Canada is based on International Standard ISO 730-1:1994, third edition, 1994-12-15, including Technical Corrigendum 1:1995. 1 Scope This part of IS0 730 specifies the dimensions and requirements of the three-point linkage for the attachment of implements or equipment to the rear of agricultural wheeled tractors. It specifies four categories to be used on different…

1 Scope 1.1 This Standard specifies minimum requirements for masonry materials and masonry construction. Notes: (1) Requirements for structural design of masonry are specified in CSA S304.1. (2) If a requirement specified in Part 9 of the National Building Code of Canada differs from a requirement specified in this Standard, the requirement specified in this Standard should be followed. 1.2…

1 Scope 1.1 This Code applies to (a) the installation of appliances, equipment, components, and accessories where oil is used for fuel purposes such as (i) forced-air furnaces; (ii) boilers; (iii) domestic water heaters; (iv) vehicle heaters; and (v) emergency power supplies for buildings; (b) the installation of all stationary and portable oil-burning equipment, including fuel…