Rechercher

This International Standard defines the procedures for noise control of mainly open plants. It is applicable to the following: _ specification of procedures for noise control during engineering of a new plant and modification/extension of existing plants (construction noise procedures are outside the scope of this International Standard but should be considered); _ definition of responsibilities…

ISO 2719:2016 describes three procedures, A, B and C, using the Pensky-Martens closed cup tester, for determining the flash point of combustible liquids, liquids with suspended solids, liquids that tend to form a surface film under the test conditions, biodiesel and other liquids in the temperature range of 40 °C to 370 °C. CAUTION - For certain mixtures no flash point, as defined, is observed;…

This International Standard specifies test methods for measuring the performance of household and similar electrical air cleaners intended for the reduction of chemical gases pollutants.

This International Standard proposal specifies technical requirements and test method for temperature sensor in radiosonde. This International Standard is applicable to the temperature measurement traceable to SI unit in boom sensors according to variations of pressure and air speed under the simulated conditions of upper air. This proposed standard will mainly provide a) Terms and definitions…

This proposed standard is applicable the analysis of plutonium (238Pu, 239Pu and 240Pu) in urine, which can be used for the internal dose monitoring of the public, occupational and rescue under accident conditions. The range of radioactivity are 1×10-4 Bq/L to 0.1 Bq/L for 238Pu and 1×10-5 Bq/L to 1×10-2 Bq/L for 239Pu and 240Pu. This standard introduces methods for the determination of…

ISO 18319:2015 specifies requirements for fibre-reinforced polymer (FRP) sheets for upgrading of concrete members. The methodologies to express the mechanical properties as characteristic values, appearance and dimensions, and sampling test are specified in this International Standard. The properties for design are calculated from the characteristic values, as prescribed in an appropriate design…

This International Standard specifies the guidelines of the method and procedure for determining the effect of temperature on atomic force microscope (AFM) nano-scale dimension measurements. The effect of temperature can be evaluated by continuously measuring the changes of the X- and Y- pitches and height of a two-dimensional (2D) calibration grating in an environmental temperature controllable…

ISO/IEC 27017:2015 gives guidelines for information security controls applicable to the provision and use of cloud services by providing: - additional implementation guidance for relevant controls specified in ISO/IEC 27002; - additional controls with implementation guidance that specifically relate to cloud services. This Recommendation | International Standard provides controls and…

ISO 14021:2016 specifies requirements for self-declared environmental claims, including statements, symbols and graphics, regarding products. It further describes selected terms commonly used in environmental claims and gives qualifications for their use. This International Standard also describes a general evaluation and verification methodology for self-declared environmental claims and…

This International Standard specifies the test method to evaluate the assistance/enhancement performance of the lower-limb wearable robots by using an anthropomorphic test dummy robot (ATDR). ATDR wears the lower-limb wearable robot and runs test instead of a human thereby ensuring the objectivity and repeatability of the test. This International Standard is applied to all wearable robots that…