Continuous mechanical handling equipment — Safety code for belt conveyors — Examples for guarding of...
Describes safety techniques for guarding the dangerous nip points of belt conveyors which occur between the belt and its pulleys or idlers. Supplements the various International Standards dealing with safety of continuous mechanical handling equipment.
1. SCOPE
1.1 This standard applies to vernier and dial type calipers and gages reading
to 0.02 mm, for precision measuring. Verniers and gages in accordance with
this standard shall be graduated with the International System of Measurement
(SI) Units.
1. Scope
1.1 This standard applied to screw type micrometer calipers for measuring
external and internal dimensions, thickness of tubing walls, and to
micrometer depth gages. Calipers and gages in accordance with this
standard shall be graduated with the International System of
Measurement (SI) Units.
This standard has been prepared as a guide for the application of
the International System of Units (SI). Information is included
on SI units, recommended application of multiples and
sub-multiples of the units, up-to-date terminology concerning the
names of quantities, conversion factors that relate the SI and
the yard/pound system, conversion and rounding of data, and dual
dimensioning.
Covers the writing, typing, and printing of dates and times when
all-numeric forms are used, and is applicable for general use. It
is more restrictive than, but is not in conflict with, the
relevant ISO standards. It departs from International Standard
ISO 3307, Information interchange Representations of time of
the day, only in that the use of 24:00:00 is permitted in
addition to 00:00:…
Non-ionizing radiation hazards in the frequency range from 10 MHz to 300 000 MHz
Summarizes the present position on difference in limits and attitudes towards non-ionizing hazards adopted by a number of different countries, and by the IEC and other international organizations, in standards and recommendations. Has the status of a technical report.
Specifies a method of determining the resolving power of a given
camera, film and development combination used in a microcopying
system or the resolution achieved in microcopies therefrom. It
provides, for this purpose, a test pattern and a test chart (ISO
test chart No. 2). The test chart should be used as part of a
test target in the manner prescribed by each relevant
International Standard…
Cinematography — Sprockets for 8 mm Type S motion-picture film — Dimensions and design
This International Standard lays down the dimensions and specifies requirements for the design of sprockets used with 8 mm Type S motion-picture raw stock or processed film.
Is based on Standard No.106 of the International Assotiation for Cereal Science and Technology (ICC). The method consists inpreparing of dough from a sample of flour and a buffered solution of sodium chloride, isolating of the wet gluten by washing this dough with a buffered solution of sodium chloride ( washing out by hand or mechanical washing out ), followed by removing of exess washing…
