Rechercher

This National Standard of Canada is based on International Standard IEC 60745-2-11:2003, and is joint with UL 60745-2-11. 1 Scope This clause of Part 1 is applicable, except as follows: 1.1 Addition: This standard applies to reciprocating saws. Tools covered by this standard include but are not limited to jigsaws and reciprocating saws (sabre saws).

This National Standard of Canada is based on International Standard IEC 60745-2-14:2003, and is joint with UL 60745-2-14. 1 Scope This clause of Part 1 is applicable except as follows: 1.1 Addition: This standard applies to planers.

This National Standard of Canada is based on International Standard IEC 60745-2-17:2003, and is joint with UL 60745-2-17. 1 Scope This clause of Part 1 is applicable except as follows: 1.1 Addition: This standard applies to routers and trimmers.

This National Standard of Canada is based on International Standard ISO 5359:2000 (second edition, 2000-11-01). Scope 1.1 This International Standard specifies requirements for low-pressure hose assemblies intended for use with the following medical gases: - oxygen; - nitrous oxide; - air for breathing; - helium; - carbon dioxide; - xenon; - specified mixtures of the gases listed above; - air…

1 Scope 1.1 General This Standard applies to the design, characteristics, construction, installation, dismantling, operation, inspection, testing, and maintenance of tower cranes. This Standard applies to tower cranes powered by electric motors or internal combustion engines and any variations thereof that retain the same fundamental characteristics. The scope includes cranes of these…

This National Standard of Canada is based on International Standard ISO 730-1:1994, third edition, 1994-12-15, including Technical Corrigendum 1:1995. 1 Scope This part of IS0 730 specifies the dimensions and requirements of the three-point linkage for the attachment of implements or equipment to the rear of agricultural wheeled tractors. It specifies four categories to be used on different…

1 Scope 1.1 This Code applies to (a) the installation of appliances, equipment, components, and accessories where oil is used for fuel purposes such as (i) forced-air furnaces; (ii) boilers; (iii) domestic water heaters; (iv) vehicle heaters; and (v) emergency power supplies for buildings; (b) the installation of all stationary and portable oil-burning equipment, including fuel…

This National Standard of Canada is equivalent to International Standard CEI/IEC 61000-2-4:2002 (second edition, 2002-06). 1 Scope This part of IEC 61000 is concerned with conducted disturbances in the frequency range from 0 kHz to 9 kHz. It gives numerical compatibility levels for industrial and non-public power distribution systems at nominal voltages up to 35 kV and a nominal frequency of 50…

This National Standard of Canada is equivalent to International Standard CEI/IEC 1000-2-6:1995 (first edition, 1995-09). 1 Scope This technical report recommends the procedures to assess the disturbance levels produced by the emission of the devices, equipment and systems installed in non-public networks in industrial environment as far as the low-frequency conducted disturbances in the power…

This National Standard of Canada is equivalent to International Standard ISO 15882:2003 (first edition, 2003-03-15). 1 Scope This International Standard provides guidance for the selection, use and interpretation of results of chemical indicators used in process definition, validation, and routine monitoring and control of sterilization processes. This International Standard is…