Information technology - Telecommunications and information exchange between systems - Near Field Co...
ISO/IEC 18092:2004 defines communication modes for Near Field Communication Interface and Protocol (NFCIP-1) using inductive coupled devices operating at the centre frequency of 13,56 MHz for interconnection of computer peripherals. It also defines both the Active and the Passive communication modes of NFCIP-1 to realize a communication network using Near Field Communication devices for networked…
Cranes — Bridge and gantry cranes — International Standards for design and manufacturing requirement...
ISO TR 16880:2004 collects the design and manufacturing requirements and recommendations for bridge and gantry cranes in ISO and IEC International Standards.
Identification cards — Integrated circuit cards — Part 11: Personal verification through biometric m...
ISO/IEC 7816-11:2004 specifies the usage of interindustry commands and data objects related to personal verification through biometric methods in integrated circuit cards. The interindustry commands used are defined in ISO/IEC 7816-4. The data objects are partially defined in this International Standard, partially imported from ISO/IEC 19785-1.
ISO/IEC 7816-11 also presents examples for…
Health informatics — Guidelines on data protection to facilitate trans-border flows of personal heal...
ISO 22857:2004 provides guidance on data protection requirements to facilitate the transfer of personal health data across national borders. It does not require the harmonization of existing national standards, legislation or regulations. It is normative only in respect of international exchange of personal health data. However, it may be informative with respect to the protection of health…
Identification cards - Integrated circuit cards - Part 11: Personal verification through biometric m...
ISO/IEC 7816-11:2004 specifies the usage of interindustry commands and data objects related to personal verification through biometric methods in integrated circuit cards. The interindustry commands used are defined in ISO/IEC 7816-4. The data objects are partially defined in this International Standard, partially imported from ISO/IEC 19785-1.
ISO/IEC 7816-11 also presents examples for…
Specification and qualification of welding procedures for metallic materials — Welding procedure tes...
ISO 15614-5:2004 specifies how a welding procedure specification is qualified by welding procedure tests.
It defines the conditions for the execution of welding procedure tests and the range of qualification for welding procedures for all practical welding operations within the range of variables listed in Clause 8.
It is intended that tests be carried out in accordance with this International…
Tools for moulding — Tool specification sheet for injection moulds
ISO 16916:2004 defines the description and specification of injection moulds to be used when requesting tools (stage of tender) and ordering tools. This International Standard gives data for material acquisition, equipment, structural design of injection moulds including the surfaces of the tool. Information relating to machine-specific data, types of operation and warranty is also contained in…
ISO 18175:2004 describes procedures for evaluating the following performance characteristics of ultrasonic pulse-echo examination instruments:
horizontal limit and linearity;
vertical limit and linearity;
resolution-entry surface and far surface;
sensitivity and noise;
accuracy of calibrated gain controls.
ISO 18175:2004 may be used for the evaluation of a complete examination system,…
ISO 14314:2004 specifies the safety requirements for RIC engine re-coil starting equipment intended for use on reciprocating internal combustion engines for land, rail and marine use, excluding engines intended for use to propel road vehicles and aircraft. It may be applied to engines intended for use to propel construction and earth-moving machines and for other applications where no other…
Microbeam analysis — Scanning electron microscopy — Guidelines for calibrating image magnification
ISO 16700:2004 specifies a method for calibrating the magnification of images generated by a scanning electron microscope (SEM) using an appropriate reference material. This method is limited to magnifications determined by the available size range of structures in the calibrating reference material. This International Standard does not apply to the dedicated critical dimension measurement SEM.
