Rechercher

Gives the requirements for two types of extruded polyolefin, flame retarded, limited fire hazard sleeving. Type A: Thin wall - Internal diameter up to 30 mm Type B: Thick wall - Internal diameter up to 30 mm These sleevings are normally supplied in the following colours: black, red, green, blue, white and yellow. These sleevings are for use up to temperatures of 90 °C. Sizes or colours other than…

Gives the requirements for one type of heat-shrinkable, flame retarded, with a nominal shrink ratio 2:1, fluid resistant polyvinylidene fluoride sleeving for use at temperatures up to 175 C. This sleeving is normally supplied with an internal diameter up to 25,4 mm, and the standard colour is transparent. Sizes or colours other than those specifically listed in this standard may be available as…

This Dual Logo International Standard is the result of an agreement between the IEC and the Institute of Electrical and Electronics Engineers, Inc. (IEEE). The original IEEE Standard was submitted to the IEC for consideration under the agreement, and the resulting IEC/IEEE Dual Logo International Standard has been published in accordance with the ISO/IEC Directives. It specifies a set of codes to…

ISO 752:2004 specifies the classifications, chemical compositions, markings and other requirements for primary zinc. It includes a table of related grades of zinc which are recognized in other International Standards. This International Standard is applicable to primary zinc only and does not include requirements for secondary zinc produced by re-melting.

ISO 21107:2004 establishes a search structure and an attribute vocabulary for identifying rolling bearings, spherical plain bearings, bearing housings and accessories, primarily with the aid of electronic media, such as the Internet. The methodology for using this International Standard in search programs is not included.

ISO 11088:2004 specifies assembly, adjustment and inspection procedures for the binding mechanisms of skis, integrating in a practical way the requirements of those International Standards which relate to skis, boots and bindings. It is intended for all individuals and institutions concerned with those procedures, and especially for sports retailers. It is applicable to a ski/binding/boot/ system…

This National Standard of Canada is equivalent to International Standard CEI/IEC 61000-4-30:2003. 1 Scope This part of IEC 61000-4 defines the methods for measurement and interpretation of results for power quality parameters in 50/60 Hz a.c. power supply systems. Measurement methods are described for each relevant type of parameter in terms that will make it possible to obtain reliable…

This National Standard of Canada is equivalent to International Standard CEI/IEC 61000-2-8:2002. 1 Scope This technical report describes the electromagnetic disturbance phenomena of voltage dips and short interruptions in terms of their sources, effects, remedial measures, methods of measurement, and measurement results (in so far as these are available). They are discussed primarily as…

La présente norme nationale du Canada est equivalente à la norme internationale CEI/IEC 60601-2-39:2003. 1.1 Scope Addition: This Particular Standard specifies the minimum safety requirements for PERITONEAL DIALYSIS EQUIPMENT as defined in 2.1.102, hereinafter referred to as EQUIPMENT. It applies to EQUIPMENT intended for use either by medical staff or under the supervision of medical…

ISO 13887:2004 establishes a system of testing for improved formability and strength of cold-reduced steel sheet in the seven grades listed in Table 1. It is suitable for applications where the surface of the sheet is of prime importance. This International Standard is not applicable to steels designated as commercial quality or drawing qualities (see ISO 3574), steels of structural quality (see…