Rechercher

2 Scope 2.1 General 2.1.1 The scope of this Standard is limited to the teleco mmunications aspect of commercial building design and construction, encompassing telecommunications considerations both within and between buildings. Telecommunications aspects are generally the pathways into which telecommunications media are placed and the rooms and areas associated with the building used…

Provides guidance for measuring the values of magnetic and electric fields with regard to exposure of human beings. The frequency range spans 15 Hz to 9 kHz. The standard covers magnetic fields with magnitudes from 100 nT to 100 mT, and electric fields from 1 V/m to 50 kV/m. Sources of fields include devices that operate at power frequencies and produce frequency harmonics. Other devices produce…

Specifies the procedure for determining the tack value of paste inks and vehicles which have low volatility and are unreactiv under normal conditions during the time span required for testing. Contains a description of the rotary tackmeters most commonly used.

Introduction The Model Code for the Protection of Personal Information being developed under the auspices of the Canadian Standards Association (CSA) has the potential to advance the cause of personal-data protection in Canada. No other country has attempted to negotiate and establish on a voluntary basis a general minimum standard for privacy protection in its private sector. As an…

1. Scope and Application 1.1 This Standard provides rules and requirements for the design, fabrication, and erection of steel structures. The design is based on limit states. The term "steel structures" refers to structural members and frames that consist primarily of structural steel components, including the detail parts, welds, bolts, or other fasteners required in…

Defines test procedures for determining the mechanical performance of precast concrete floors made of a single piece, or made up of precast joists (reinforced concrete or precast concrete) completed with filler blocks and concrete poured in situ. The parameters measured are: the maximum load, which does not result in collapse, the instantaneous and deferred deformations under imposed load, and…

The principle of the method specified is calculation of the pitch diameter of the belt operating in the pulley on a test fixture by measuring the rotational frequency of the pulley and either the belt velocity over a straight span or the centre distance between the pulleys and the time of rotation of the belt, and calculation of the effective line differential.

1.1 This Standard describes zinc-coated steel wire strand suitable for use as guys, suspension strand, span wires, and overhead ground wire strand. Overhead ground wire strand for electric power transmission is produced free of wire joints. Included are requirements for Grades 110, 160, 180, and 220 [800, 1100, 1300 and 1500]. Zinc-coatings for all grades include hot-dip Class A and electro-…

1. Scope and Application 1.1 This Standard provides rules and requirements for the design, fabrication, and erection of steel structures where the design is based on limit states. The term "steel structures" refers to structural members and frames that consist primarily of structural steel components, including the detail parts, welds, bolts, or other fasteners required in…

Specifies a method for the determination of the compressive strength in the machine and cross directions of paper and board using a short span compression tester. Applies to papers and boards used for the manufacture of containers and boxes. May also be used for laboratory sheets prepared for the testing of pulp.