Rechercher

1.1 This Standard specifies the procedure for certification of prefabricated buildings, and partially or fully enclosed modules and panels for buildings of any occupancy. It provides requirements for a) certification of the factory quality program; b) certification of the prefabricated product; c) auditing of the factory quality program; and d) in-factory inspection of the prefabricated…

1.1 This Standard applies to a) direct expansion ground source heat pumps for systems using ground heat exchangers as a thermal source or sink for heating and/or cooling, with or without a supplementary heating source; and b) unitary single package or split system liquid source and ground source heat pumps for all systems using groundwater, submerged heat exchangers, or ground heat…

IEC 61400-13:2015(B) describes the measurement of fundamental structural loads on wind turbines for the purpose of the load simulation model validation. The standard prescribes the requirements and recommendations for site selection, signal selection, data acquisition, calibration, data verification, measurement load cases, capture matrix, post-processing, uncertainty determination and reporting…

L'IEC 61400-13:2015(B) décrit le mesurage des charges structurelles fondamentales sur les éoliennes à des fins de validation des modèles de simulation de charges. La norme spécifie les exigences et recommandations concernant le choix du site, la sélection des signaux, l'acquisition des données, l'étalonnage, la vérification des données, les cas de charges de mesure, la matrice de…

ISO 11799:2015 specifies the characteristics of repositories used for the long-term storage of archive and library materials. It covers the siting and construction and renovation of the building and the installation and equipment to be used both within and around the building. It applies to all archive and library materials held in repositories, where mixed media may be stored together with paper…

IEC TS 62257-6:2015(E) describes the various rules to be applied for acceptance, operation, maintenance and replacement of decentralized rural electrification systems which are designed to supply electric power for sites which are not connected to a large interconnected system, or a national grid, in order to meet basic needs. This technical specification proposes a methodology to achieve the…

IEC TS 62257-4:2015(E) provides a method for describing the results to be achieved by the electrification system independently of the technical solutions that could be implemented. The purpose is to provide a method to assist project contractors and project developers to select and design the electrification system for isolated sites while matching the identified needs, such as those described in…

IEC TS 62257-5:2015(E) specifies the general requirements for the protection of persons and equipment against electrical hazards to be applied in decentralised rural electrification systems. Requirements dealing with protection against electric shock are based on basic rules from IEC 61140 and IEC 60364. Decentralized Rural Electrification Systems are designed to supply electric power for sites…

ISO 29404:2015 specifies content and format of the messages initiating and controlling the physical movement of wind turbine generator (WTG) components from suppliers to the construction site during the construction phase as well as for repair and maintenance purposes. ISO 29404:2015 is applicable to all organizations involved in the production, transportation, storage and installation of WTG…

IEC 62153-4-7:2015 describes a triaxial method, suitable to determine the surface transfer impedance and/or screening attenuation and coupling attenuation of mated screened connectors (including the connection between cable and connector) and cable assemblies. This method could also be extended to determine the transfer impedance, coupling or screening attenuation of balanced or multipin…