Spray-Application of Rigid Polyurethane Cellular Plastic Thermal
Insulation for Building Constructi...
1.1 This standard provides procedures to installers of spray-applied rigid
polyurethane cellular plastic thermal insulation in building construction. The
insulation is intended to be sprayed only into open cavities or onto surfaces
at the construction site. After the insulation application, the cavities or
surfaces can be enclosed.
1.2 The procedures include selection of chemical…
Commentary on the Principles for Quality Assurance Programs of CSA N286 Series Standards
1. Scope
1.1 This Special Publication is a commentary on the principles for quality assurance programs to be implemented in the phases of a nuclear power plant life-cycle, including site assessment, procurement, design, construction, commissioning, operations, and decommissioning.
Definitions and General Safety Requirements for Park Model Trailers
1. Scope
1.1
This Standard provides the definition of the term park model trailer as used in
the CAN/CSA-Z241 Series, Park Model Trailers. It also gives general safety
requirements that apply to the other Standards in the CAN/CSA-Z241 Series.
1. Scope
1.1 Requirement Specification
This Standard specifies vehicular requirements for park model trailers
including minimum requirements for the coupling and tongue or A-frame as well
as for the running gear of the trailer.
1.2 Standard Application
This Standard applies to park model trailers equipped with limited-use running
gear.
1. Scope
1.1 General
This Standard outlines the minimum requirements for materials, products,
equipment, and workmanship needed to ensure that park model trailers will
provide adequate
(a) structural strength and rigidty;
(b) protection against corrosion, decay, insects, and other similar
destructive forces;
(c) protection against the hazards of fire;
(d) resistance to the elements…
Plumbing System Requirements for Park Model Trailers
1. Scope
1.1 General
This Standard sets the minimum installation requirements and material standards
for a plumbing system in a park model trailer.
1.2 Disclaimer
This Standard is not intended as a design specification or an instruction
manual for untrained persons.
Installation Requirements for Propane Appliances and Equipment in Park
Model Trailers
1. Scope
1.1
This Standard applies to the factory installation of propane appliances and
equipment in park model trailers.
Note: CGA Standard CAN1-B149.2 was used as a basis for the preparation of this
Standard and should be consulted for installations not covered here.
1. Scope
1.1 General
This Standard applies to the electrical requirements for park model trailers
that are intended to be connected by a cord and attachment plug to a source of
electrical supply not exceeding 250 V between conductors or 150 V to ground and
50 A maximum in accordance with the Rules of the Canadian Electrical Code, Part
I.
1.2 Nonapplicable Types
This Standard does…
1. Scope
Z241.0
1.1 This Standard provides the definition of the term park model trailer as used in the CAN/CSA-Z241 Series, Park Model Trailers. It also gives general safety requirements that apply to the other Standards in the CAN/CSA-Z241 Series.
Z241.1
1.1 Requirement Specification This Standard specifies vehicular requirements for park model trailers including minimum…
Measurement of total discharge in open channels — Electromagnetic method using a full-channel-width ...
Specifies procedures for the establishment and operation of a gauging station, equipped with an electromagnetic flow-meter, in an open channel or a closed conduit with a free water surface. The field of application is limited to sites where the magnetic field is generated by an electromagnetic coil which traverses the full channel width. Does not apply to flow-meters which operate by using the…
