Rechercher

IEC PAS 61851-1-1:2023 applies to a new type of AC EV supply equipment for charging electric road vehicles, with a rated supply voltage up to 1 000 V AC and a rated output voltage up to 1 000 V AC. This document provides specific requirements for AC charging system using type 4 vehicle coupler. Type 4 vehicle coupler is under consideration by SC23H. Vehicle inlet and vehicle connector of type…

IEC 63076:2019+AMD1:2023 applies to electrical systems aboard vehicles of the trolley bus type, as defined in 3.1, fed with a nominal line voltage (Un) between 600 V DC and 750 V DC. This document defines the requirements and constructional advice, especially to avoid electrical danger to the public and to staff. Where special requirements exist for trolley buses, advice is given for mechanical…

This document specifies requirements and recommendations for software update engineering for road vehicles on both the organizational and the project level. This document is applicable to road vehicles whose software can be updated. The requirements and recommendations in this document apply to vehicles, vehicle systems, ECUs, infrastructure, and the assembly and deployment of software update…

This document specifies general requirements and definitions of the liquefied petroleum gas fuel component: remotely controlled service valve with excess flow valve. This component is intended for use on the types of motor vehicles as defined in ISO 3833. It also provides general design principles and specifies requirements for instructions and marking. This document is applicable to vehicles (…

This document specifies general requirements for the pressure and/or temperature sensors liquefied petroleum gas fuel, intended for use on the types of motor vehicles as defined in ISO 3833. It also provides general design principles and specifies requirements for instructions and marking. This document is applicable to vehicles (mono-fuel, bi-fuel or dual-fuel applications) using gaseous fuels…

This document specifies general requirements for the fuel pump component of liquefied petroleum gas fuel, intended for use on the types of motor vehicles as defined in ISO 3833. It also provides general design principles and specifies requirements for instructions and marking. This document is applicable to vehicles (mono-fuel, bi-fuel or dual-fuel applications) using gaseous fuels in accordance…

This document specifies general requirements of the liquefied petroleum gas fuel component, excess flow valve, intended for use on the types of motor vehicles as defined in ISO 3833. It also provides general design principles and specifies requirements for instructions and marking. This document is applicable to vehicles (mono-fuel, bi-fuel or dual-fuel applications) using gaseous fuels in…

This document references the latest publication of SAE J1962. On-board diagnostic (OBD) regulations require road vehicles to be equipped with a standardized connector for purposes of access to OBD information by external test equipment. This document describes the requirements for the physical connection and associated pin usage to allow for standard access to the OBD data. This document is…

This document specifies graphical symbols for the purposes of public information. This document is generally applicable to public information symbols in all locations and all sectors where the public has access. However, it is not applicable to safety signs or those sectors subject to specific regulations (e.g. traffic signs on public roads). This document specifies the original symbols that can…

This document specifies tests and requirements for the pressure relief device (PRD), a compressed natural gas (CNG) fuel system component intended for use on the types of motor vehicles defined in ISO 3833. This document is applicable to vehicles (mono-fuel, bi-fuel or dual-fuel applications) using natural gas in accordance with ISO 15403-1. It is not applicable to the following: a)      …