Rechercher

ISO/PAS 21308-1:2007 describes general principles for the exchange of data between truck chassis manufacturers and bodywork manufacturers. It applies to commercial vehicles as defined in ISO 3833, having a maximum gross vehicle mass greater than 3 500 kg. The process of exchanging product data can involve chassis manufacturer, chassis importer, chassis dealer, one or…

ISO 16750-3:2007 applies to electric and electronic systems/components for road vehicles. ISO 16750-3:2007 describes the potential environmental stresses, and specifies tests and requirements recommended for the specific mounting location on/in the vehicle. ISO 16750-3:2007 describes the mechanical loads.

ISO 6460-3:2007 specifies the methods of measurement for fuel consumption at a constant speed on the road and on the chassis dynamometer. It is applicable to motorcycles as defined in ISO 3833 equipped with a spark ignition engine (four-stroke engine, two-stroke engine or rotary piston engine) or a compression ignition engine.

ISO 7637-3:2007 establishes a bench top test for the evaluation of the immunity of devices under test (DUTs) to transient transmission by coupling via lines other than supply lines. The test transient pulses simulate both fast and slow transient disturbances, such as those caused by the switching of inductive loads and relay contact bounce. Three test methods are described in ISO 7637-3:2007…

1. SCOPE 1.1 This standard applies to four types of automotive (on-road) diesel fuel, Type A-LS, Type A-ULS, Type B-LS and Type B-ULS, suitable for use in high-speed diesel engines that require low-sulphur diesel fuel to meet emission control regulations. 1.2 All types of this fuel can be used in all high-speed diesel-powered equipment. 1.2.1 Types A-LS and A-ULS are intended for use in…

1. SCOPE 1.1 This standard defines equipment requirements, performance criteria, and operating and testing procedures for the implementation of a vapour control system (VCS) in gasoline distribution networks including terminals, bulk plants, service stations and cargo tanks, commonly known as Stage I. (See Figure 1 for a schematic representation.) 1.1.1 This standard does not include vapour…

ISO 16850:2007 specifies a test method to simulate the child head impact of a child pedestrian to the bonnet top of passengers vehicles or some light truck vehicles, as defined in ISO 3833. The purpose of this test method is to simulate frontal impact of a vehicle, laterally to a pedestrian. The impact device to be used in this test method will be robust for a vehicle impact velocity of up to 11…

ISO 362-1:2007 specifies an engineering method for measuring the noise emitted by road vehicles of categories M and N under typical urban traffic conditions. It excludes vehicles of category L1 and L2, which are covered by ISO 9645, and vehicles of category L3, L4 and L5 covered by ISO 362-2. The specifications are intended to reproduce the level of noise generated by the principal noise sources…

ISO 11451-3:2007 specifies methods for testing the immunity of passenger cars and commercial vehicles to electromagnetic disturbances from on-board transmitters connected to an external antenna and portable transmitters with integral antennas, regardless of the vehicle propulsion system (e.g. spark ignition engine, diesel engine, electric motor).

ISO 11452-8:2007 specifies tests for the electromagnetic immunity of electronic components for passenger cars and commercial vehicles, regardless of the propulsion system (e.g. spark-ignition engine, diesel engine, electric motor), to magnetic fields generated by power transmission lines and generating stations and some powerful electrical equipment, such as motors. To perform this test, the…