Rechercher

Scope 1.1 This Standard specifies essential elements in implementing a program for using ethylene oxide to sterilize medical devices in health care facilities, with the object of achieving an adequate level of sterility assurance and minimizing the risk of injury to health care facility personnel and patients. Notes: (1) The term "health care facility" includes, but is not limited to,…

IEC 60601-2-2:2009 specifies particular requirements for the basic safety and essential performance of high frequency surgical equipment and high frequency surgical accessories. This particular standard amends and supplements IEC 60601-1 (third edition, 2005): Medical electrical equipment - Part 1: General requirements for basic safety and essential performance. This fifth edition cancels and…

ISO 27996:2009 is applicable to the general requirements for data recording procedures, packaging, and storing of elastomeric seals and seal assemblies which include an elastomeric element prior to the seal being assembled into hardware components. The requirements for packaging are an integral part of the controlled storage procedure and provide a means of positive product identity from the time…

ISO 21439:2009 specifies methods for the determination of absorbed-dose distributions in water or tissue that are required prior to initiating procedures for the application of beta radiation in ophthalmic tumour and intravascular brachytherapy]. Recommendations are given for beta-radiation source calibration, dosemetry measurements, dose calculation, dosemetric quality assurance, as well as for…

ISO 9927-1:2009 specifies the inspections to be carried out on cranes as defined in ISO 4306-1. It does not cover the inspections carried out prior to the first use of the crane.

C22.4 No. 1-09 Objective-based industrial electrical code Preface This is the first edition of CSA C22.4 No. 1, Objective-based industrial electrical code. Permission to use extracts from IEC 60364-1:2005 was provided by Standards Council of Canada, in co-operation with IHS Canada. No further reproduction is permitted without prior written approval from Standards Council of Canada. 0…

1. SCOPE 1.1 This standard applies to two grades of kerosene-type aviation turbine fuel (grades JET A and JET A-1), consisting entirely of petroleum-derived hydrocarbons, naturally occurring non-hydrocarbons and additives as specified herein. Kerosene-type aviation turbine fuels are distillates having a minimum flash point of 38°C. 1.1.1 The two grades differ only in freezing point. Grade JET A…

ISO 2082:2008 specifies the requirements of electroplated coatings of cadmium with supplementary treatments on iron and steel. It includes information that is to be supplied by the purchaser to the electroplater, and describes coating requirements, including those for heat treatment before and after electroplating. It is not applicable to coatings applied to sheet, strip or wire in the non-…

ISO 2081:2008 specifies requirements for electroplated coatings of zinc with supplementary treatments on iron or steel. It includes information to be supplied by the purchaser to the electroplater, and the requirements for heat treatment before and after electroplating. It is not applicable to zinc coatings applied to sheet, strip or wire in the non-fabricated form, to close-coiled springs, or…

ISO 22108:2008 describes the identification of critical non-flight items in space flight hardware and the procedure to account for their complete removal prior to flight. ISO 22108:2008 is used in context with project-specific quality requirements and procedures related to flight hardware and related activities prior to launch and at the launch site. Verification of removal of critical non-flight…