Rechercher

ISO 10350 identifies specific test procedures for the acquisition and presentation of comparable data for certain basic properties of plastics. In general, each property is specified by a single experimental value, although in certain cases properties are represented by two values obtained under different test conditions or along different directions in the material. The properties included are…

1.1 This standard sets out criteria for specification of air barrier assemblies that may be used in design specification documents or in manufacturer’s product literature. 1.2 This standard provides the requirements and test methods for an air barrier assembly used in applications for both low-rise and high-rise buildings. 1.3 The test methods described in this standard involve measuring the…

1. SCOPE 1.1 This standard applies to automotive fuel composed of 50 to 85% by volume denatured fuel ethanol and gasoline strictly for use in flexible fuel vehicles over a wide range of climatic conditions. 1.1.1 Fuel produced to this standard is not for use in conventional vehicles designed to operate on gasoline containing up to 10% by volume ethanol. 1.1.2 Precautions for the use of…

ISO 26945:2011 specifies electrodeposited coatings of tin-cobalt alloy of approximate composition 75 % (mass fraction) to 80 % (mass fraction) tin, remainder cobalt, as a substitute for decorative chromium coatings of 0,1 µm to 0,3 µm thickness. Hardness and wear resistance properties of the coatings obtained are not equivalent to those of chromium coatings, but similar to those of tin-nickel…

IEC 60212:2010 gives the accepted conditions of exposure time, temperature, atmospheric humidity and liquid immersion for use in testing solid electrical insulating materials. The range is sufficiently wide to enable suitable conditions to be selected so that either of the primary objects, set out below as a) and b), of conditioning can be achieved. These objectives aim to obtain greater…

ISO 9698:2010 specifies the conditions for the determination of tritium activity concentration in samples of environmental water or of tritiated water using liquid scintillation counting. The choice of the analytical procedure, either with or without distillation of the water sample prior to determination, depends on the aim of the measurement and the sample characteristics. Direct measurement of…

ISO 178:2010 specifies a method for determining the flexural properties of rigid and semi-rigid plastics under defined conditions. A standard test specimen is defined, but parameters are included for alternative specimen sizes for use where appropriate. A range of test speeds is included. The method is used to investigate the flexural behaviour of the test specimens and to determine the flexural…

1 Scope 1.1 Purpose This International Standard specifies the set of definitions, rules and steps for applying the IFPUG functional size measurement (FSM) method. 1.2 Conformity This International Standard is conformant with all mandatory provisions of ISO/IEC 14143-1:2007. 1.3 Applicability This International Standard can be applied to all functional domains. NOTE IFPUG continues…

1.1 This Standard specifies the physical property requirements and test methods to determine the material properties for light density, open cell spray applied semi-rigid polyurethane foam, used as a thermal insulation for building applications, whether applied on a building site or in a prefabrication (manufacturing) facility. 1.2 The spray polyurethane foam system installer site manufactures…

CSA Preface This is the first edition of CAN/CSA-ISO 26825, Anaesthetic and respiratory equipment - User-applied labels for syringes containing drugs used during anaesthesia - Colours, design and performance, which is an adoption, without modification, of the identically titled ISO (International Organization for Standardization) Standard 26825 (first edition, 2008-08-15). It replaces CAN/CSA-…