Rechercher

ISO 17212:2012 provides and describes the usual procedures for the preparation of component surfaces prior to bonding for either laboratory evaluation or the process of construction. It is applicable to metal and plastic surfaces that are commonly encountered.

1.1 This Standard specifies the requirements for stay in place, modular expanded polystyrene (EPS) Insulating Concrete Form (ICF) units. Once filled with concrete, the ICF units remain in place as the thermal insulation for the resulting cast-in-place concrete wall of uniform cross-section and thickness. 1.2 The requirements of this Standard apply to ICFs that act as permanent formwork for cast-…

ISO16431:2012 defines methods to measure the cleanliness of a fluid in an assembled hydraulic fluid power system, to verify a required system cleanliness upon release of the system from the production area, and if needed, to clean the system to the required cleanliness level. The clean-up procedure specified in ISO16431:2012 is not intended to replace proper system…

IEC 61340-4-4:2012 specifies requirements for flexible intermediate bulk containers (FIBC) between 0,25 m3 and 3 m3 in volume, intended for use in hazardous explosive atmospheres. The explosive atmosphere may be created by the contents in the FIBC or may exist outside the FIBC. The requirements include: - classification and labelling of FIBC; - classification of inner liners; - specification of…

1. SCOPE 1.1 This standard applies to four grades of oxygenated gasoline to which no lead or phosphorus compounds have been added, and in which the oxygenate consists essentially of ethanol. They are intended for use in spark ignition engines under a wide range of climatic conditions. 1.2 This standard is not intended to apply to the mixing of oxygenated gasolines and gasolines either at the…

1. SCOPE 1.1 This standard applies to denatured fuel ethanol, a blendstock that is used solely as a component of automotive spark ignition fuels. 1.1.1 These automotive spark ignition fuels include: CAN/CGSB-3.511 — Oxygenated Automotive Gasoline Containing Ethanol (E1-E10), and CAN/CGSB-3.512 — Automotive Ethanol Fuel (E50–E85). 1.2 The testing and evaluation of a product against this…

1. SCOPE 1.1 This standard applies to two types of automotive diesel fuel containing low levels of biodiesel: Type A-ULS, Bx and Type B-ULS, Bx. 1.1.1 Bx represents biodiesel fuel containing x percent by volume of biodiesel component in the range of 1.0 to 5%. 1.2 Fuel to this standard is intended for use in high-speed diesel engines that require ultra low sulphur diesel fuel to meet emission…

1. SCOPE 1.1 This standard applies to one class of Type B ultra low sulphur diesel fuel (<15 ppm S) containing from 6% to 20% by volume of biodiesel. 1.1.1 Users of fuel meeting this standard are advised to refer to the owner’s manual of their vehicle, engine or equipment, or to consult with their equipment’s manufacturer regarding the suitability of the specific fuel blend prior to its use…

1. SCOPE 1.1 This standard applies to one grade of biodiesel that is intended for use as a blending component in middle distillate fuels. 1.1.1 Biodiesel meeting this standard is not intended for use as a fuel in its neat form. 1.2 The testing and evaluation of a product against this standard may require the use of materials and/or equipment that could be hazardous. This document does not…

1. SCOPE 1.1 This standard applies to four grades of gasoline to which no lead or phosphorus compounds have been added. They are intended for use in spark ignition engines under a wide range of climatic conditions. 1.2 This standard is not intended to apply to the mixing of oxygenated gasolines and gasolines, either at the point of retail sale or after the point of retail sale. 1.3 Gasoline…