Rechercher

ISO 17664:2017 specifies requirements for the information to be provided by the medical device manufacturer for the processing of a medical device that requires cleaning followed by disinfection and/or sterilization to ensure that the device is safe and effective for its intended use. This includes information for processing prior to use or reuse of the medical device. The provisions of ISO 17664…

ISO 28597:2017 specifies, for quality levels expressed as nonconforming items per million items, procedures for estimating the quality level of a single entity (e.g. a lot) and, when the production process is in statistical control, for estimating the process quality level based on evidence from several samples. Procedures are also specified for using this information when selecting a suitable…

The ISO 10350 series identifies specific test procedures for the acquisition and presentation of comparable data for certain basic properties of plastics. In general, each property is specified by a single experimental value, although in certain cases properties are represented by two values obtained under different test conditions. The properties included are those presented conventionally in…

ISO 2143 specifies a method of estimating the loss of absorptive power of anodic oxidation coatings that have undergone a sealing treatment, by dye absorption after acid pretreatment. The method is suitable for use as a production control method and can be applicable to anodic oxidation coatings which may be subjected to weathering or aggressive environments, or where resistance to staining is…

1.1 This practice covers the preparation, handling, testing, and procedure for using the ethanol-chlorobenzene (ECB) dosimetry system to measure absorbed dose to water when exposed to ionizing radiation. The system consists of a dosimeter and appropriate analytical instrumentation. For simplicity, the system will be referred to as the ECB system. The ECB dosimeter is classified as a type I…

ISO 18557 presents guidelines for sampling strategies and characterization processes to assess the contamination of soils, buildings and infrastructures, prior to remediation and/or to check that the remediation objectives have been met (final release surveys). The principles presented need to be appropriately graded as regards the specific situations concerned (size, level of contamination?). It…

This standard provides dimensional and performance requirements for safety, durability and structural adequacy of free-standing components of office desk/table and storage products, including benching systems. Vertical filing cabinets are not considered storage products for the purpose of this standard and are not covered in this standard. This standard also provides dimensional and adjustment…

This method describes a procedure for determining the filter plugging tendency of diesel fuels at low temperature usually due to the formation of wax crystals (see Note in 6.1). The method applies to all distillate diesel fuels. Fuels are expected to provide satisfactory fuel flow in automotive equipment at temperatures equal to or higher than the minimum pass temperature as described in 3.1.1…

IEC 62820-2:2017 specifies the technical requirements for the composition, function, performance and testing methods of Advanced Security Building Intercom Systems. This document is applicable for intercom systems used for any advanced security communication in buildings. Advanced security building intercom systems (ASBIS) are used for rapid emergency and danger messages verification by voice…

This standard provides dimensional and performance requirements for safety, durability and structural adequacy of interconnecting panels and panel-supported components such as work surfaces, drawers and storage units. Panels may have the capability for management of electrical and communications wiring as well as acoustical properties. This standard also provides dimensional and adjustment…