Textiles — Methods for the removal of non-fibrous matter prior to quantitative analysis of fibre mix...
Describes procedures for the removal of certain commonly found types of non-fibrous substances from fibres. Fibres to which the procedures are applicable and those to which they are not applicable are listed in the table, in relation to the non-fibrous substances to be removed. The names of these fibres are defined in ISO 2076.
Application of Asphalt Primer for Asphalt Roofing, Dampproofing and
Waterproofing
Scope
1.1 This standard describes the procedure recommended for application of asphalt primer covered by 37-GP-9Ma for the following uses:
a. to prime new concrete, gypsum or steel roof decks prior to appliation of thermal insulation and/or asphalt built-up roofing.
b. to treat weathered surfaces of asphalt roofing prior to either recovering with a new asphalt roofing sheet, or…
Subland twist drills with Morse taper shanks for holes prior to tapping screw threads
Lays down only metric dimensions, which are the only recommended dimensions in the future for subland twist drills. The drills have been designed to produce holes prior to tapping metric threads over a selected range of M 8 to M 30. Unless otherwise stated, these drills will be rigth-hand cutting. Supplements ISO 2306.
Subland twist drills with parallel shanks for holes prior to tapping screw threads
Lays down only metric dimensions, which are the only recommended dimensions in the future for these subland twist drills. The drills have been designed to produce holes prior to tapping metric threads over selected range of M 3 to M 14. Unless otherwise stated, these drills will be rigth-hand cutting. Supplements ISO 2306.
Aircraft — Radio frequency flexible coaxial cables — Dimensions and electrical characteristics
Specifies these quantities for a limited range of cables. Relates to cables in two categories of operational temperature ranges, namely from -40 °C to +85 °C and from -55 °C to +200 °C. An annex is included to list those cables which were in use prior to the publication of this standard. Furthermore describes the construction and manufacture and the designation.
General principles for sampling airborne radioactive materials
Sets forth the principles for collecting representative samples and prescribes acceptable methods and materials for gas and particle sampling (collection of the samples, and not their measurement), limited to sampling in installations where work with radioactive materials is conducted, including sampling effluent gases prior to, or at, the point of release to the atmosphere, and with the primary…
Specifies the sizes of these drills for ISO metric threads (tables 1 and 2). ISO inch threads (tables 3 and 4) and pipe threads (tables 5 and 6). Applies to screw threads of normal length of engagement, the drill diamter being approximately equal to the nominal diameter of the thread minus the pitch. The sizes (except for those sizes indicated by an asterisk) have been selected from ISO 235 and…
Standard conditions for use prior to and during the testing of solid electrical insulating materials
Gives specifications for materials likely to be affected by exposure time, temperature, atmospheric humidity and immersion in liquids, in order to establish the atmospheres to which the test specimens should be exposed before testing and the conditions under which the tests are to be made.
Standard conditions for use prior to and during the testing of solid electrical insulating materials
Gives specifications for materials likely to be affected by exposure time, temperature, atmospheric humidity and immersion in liquids, in order to establish the atmospheres to which the test specimens should be exposed before testing and the conditions under which the tests are to be made.
