Intégration des systèmes entreprise-contrôle - Partie 3: Modèles d'activités pour la gestion de...
L’IEC 62264-3:2016 définit des modèles de gestion des opérations de fabrication permettant l’intégration des systèmes de commande d’entreprise. Les activités définies dans le présent document sont cohérentes avec les définitions des modèles d’objets données dans l’IEC 62264-1. Les activités modélisées agissent entre les fonctions de planification et de logistique d’entreprises, définies comme…
Explosive atmospheres — Part 35-1: Caplights for use in mines susceptible to firedamp — General requ...
This part of IEC 60079-35 specifies requirements for the construction, testing and marking of
caplights, including caplights with a point of connection for other equipment, for use in mines
susceptible to firedamp (Group I – electrical equipment for explosive gas atmospheres as
defined in IEC 60079-0). It deals only with the risk of the caplight becoming a source of
ignition.
The requirements for…
Medical electrical equipment — Part 2-62: Particular requirements for the basic safety and essential...
This International Standard applies to the BASIC SAFETY and ESSENTIAL PERFORMANCE of HIGH
INTENSITY THERAPEUTIC ULTRASOUND EQUIPMENT as defined in 201.3.218, hereafter referred to as
ME EQUIPMENT.
This International Standard adds or replaces clauses listed in the IEC 60601-1 that are
specific for HIGH INTENSITY THERAPEUTIC ULTRASOUND EQUIPMENT.
If a clause or subclause is specifically intended to…
Photovoltaic systems — Design qualification of solar trackersSystèmes photovoltaïques — Qualificatio...
This International Standard is a design qualification standard applicable to solar trackers for
photovoltaic systems, but may be used for trackers in other solar applications. The standard
defines test procedures for both key components and for the complete tracker system. In
some cases, test procedures describe methods to measure and/or calculate parameters to be
reported in the defined…
Live working – Phase comparators – Part 1: Capacitive type to be used for voltages exceeding 1 kV a....
1 Scope
This part of IEC 61481 is applicable to portable phase comparators of capacitive type to be
used on electrical systems for voltages exceeding 1 kV a.c. and frequencies of 50 Hz and/or
60 Hz.
This standard is applicable to:
?? single-pole phase comparators of capacitive type operating with a memory system up to
36 kV a.c.,
?? two-pole phase comparators of capacitive type operating with a…
Live working – Phase comparators – Part 2: Resistive type to be used for voltages from 1 kV to 36 kV...
1 Scope
This part of IEC 61481 is applicable to portable phase comparators of resistive type to be
used on electrical systems for voltages from 1 kV a.c. to 36 kV a.c. and frequencies of 50 Hz
and/or 60 Hz.
This standard is applicable to phase comparators of resistive type used in contact with the
bare conductive parts to be compared:
?? as a complete device including its insulating element or…
Live working - Voltage detectors - Part 3: Two-pole low-voltage typeTravaux sous tension – Détecteur...
1 Scope
This part of IEC 61243 is applicable to hand-held two-pole voltage detectors with their
accessories (crocodile clips and detachable leads) to be used in contact with parts of
electrical systems:
– for a.c. voltages not exceeding 1 000 V at nominal frequencies between 16 2 3 Hz and up
to 500 Hz,
and/or
– for d.c. voltages not exceeding 1 500 V.
NOTE The a.c. voltages defined in…
Electromagnetic compatibility (EMC) — Part 4-6: Testing and measurement techniques —Immunity to cond...
This part of IEC 61000 relates to the conducted immunity requirements of electrical and
electronic equipment to electromagnetic disturbances coming from intended radio-frequency
(RF) transmitters in the frequency range 150 kHz up to 80 MHz. Equipment not having at least
one conducting wire and/or cable (such as mains supply, signal line or earth connection)
which can couple the equipment to…
Secondary lithium-ion cells for the propulsion of electric road vehicles —Part 2: Reliability and ab...
This part of IEC 62660 specifies test procedures to observe the reliability and abuse
behaviour of secondary lithium-ion cells used for propulsion of electric vehicles including
battery electric vehicles (BEV) and hybrid electric vehicles (HEV).
The objective of this standard is to specify the standard test procedures and conditions for
basic characteristics of lithium-ion cells for use in…
Secondary lithium-ion cells for the propulsion of electric road vehicles —Part 1: Performance testin...
This part of IEC 62660 specifies performance and life testing of secondary lithium-ion cells
used for propulsion of electric vehicles including battery electric vehicles (BEV) and hybrid
electric vehicles (HEV).
The objective of this standard is to specify the test procedures to obtain the essential
characteristics of lithium-ion cells for vehicle propulsion applications regarding capacity,…