Pulps — Estimation of dirt and shives — Part 4: Instrumental inspection by reflected light using Equ...
ISO 5350-4:2006 specifies a method using instrumental inspection by reflected light for the estimation of visible dirt and shives in pulp manufactured in sheets, in terms of Equivalent Black Area (EBA) of dirt specks within the physical area range of 0,02 mm2 to 3,0 mm2. Using the algorithm prescribed in ISO 5350-4:2006, the maximum dirt size is limited to 3,0 mm2. Extension to other speck sizes…
Leather — Physical and mechanical tests — Determination of fogging characteristics
ISO 17071:2006 specifies two alternative methods for determining the fogging characteristics of leathers used in the passenger compartments of motor vehicles, namely Method A and Method B. These are two different test procedures to measure the volatile components and there is no mathematical correlation between the results obtained with Method A and those with Method B.
Method A determines by…
Béton préfabriqué - Constituants et exécution des travaux
1 Domaine d'application
1.1 Généralités
Cette norme établit les exigences applicables aux constituants et aux méthodes de fabrication, de transport et de mise en place du béton préfabriqué architectural, structural et spécial.
Note : Cette norme devrait être prescrite pour les éléments en béton préfabriqué utilisés dans la construction
à voussoirs.
1.2 Dessins d'atelier
Cette…
Acoustics — Measurement of sound insulation in buildings and of building elements — Part 16: Laborat...
ISO 140-16:2006, as a complement to ISO 140-3, specifies the laboratory measurement of the improvement of the sound-reduction index of a wall or ceiling when covered by an additional acoustical lining. It also provides for individual non-standardized basic elements. ISO 140-16:2006 does not deal with the sound-reduction improvement by linings on flexible lightweight structures, such as timber-…
Pulps — Estimation of dirt and shives — Part 1: Inspection of laboratory sheets by transmitted light
ISO 5350-1:2006 specifies a method for the estimation by transmitted light of the visible dirt and shives in laboratory sheets prepared from pulp. It is, in principle, applicable to all kinds of pulp, although it is mainly intended for pulp that is not manufactured in sheet form.
ISO 5350-1:2006 can also be applied to mill sheeted pulp, if the sheets have high grammage or are very opaque for…
Petroleum products — Determination and application of precision data in relation to methods of test
ISO 4259:2006 covers the calculation of precision estimates and their application to specifications. In particular, it contains definitions of relevant statistical terms, the procedures to be adopted in the planning of an inter-laboratory test programme to determine the precision of a test method, the method of calculating the precision from the results of such a programme, and the procedure to…
Electromagnetic compatibility (EMC) - Part 6-3: Generic standards - Emission standard for residentia...
This part of IEC 61000 for EMC emission requirements applies to electrical and electronic apparatus intended for use in residential, commercial and light-industrial environments. Emission requirements in the frequency range 0 Hz to 400 GHz are covered. No measurement needs to be performed at frequencies where no requirement is specified. This generic EMC emission standard is applicable if no…
ISO 21671:2006 specifies the dimensions and other requirements for the most commonly used polishers which are used at the working place of the dentist and/or in the dental laboratory.
ISO 21671:2006 is applicable to unmounted and mounted polishers.
