Rechercher

This International Standard specifies methods for the estimation of measurement uncertainty of chemical and physicochemical methods in single laboratories based on validation data and analytical quality control results obtained within the field of water analysis. NOTE 1 The principles of the estimation of uncertainty specified in this International Standard are consistent with the principles…

This document defines key terms and parameters applied in the analysis of cognitive and visual-manual workload induced by transport information and control systems (TICS). It provides guidelines and minimum requirements on equipment and procedures for analysing cognitive and visual-manual load including assessment of TICS to: — plan evaluation trials; — specify (and install) data capture…

This document specifies, for flexible and rigid cellular polymeric materials, laboratory procedures which are intended to imitate the effects of naturally occurring reactions such as oxidation or hydrolysis by humidity. The physical properties of interest are measured before and after the application of the specified treatments. Test conditions are only given for open cellular latex, both open-…

ISO 13347-2:2004 gives a detailed description of reverberant room methods for the determination of fan sound power levels. It is for use under standardized laboratory conditions and recognises that tests in situ are subject to increased uncertainty. These test procedures are not necessarily appropriate to site test conditions. Acoustic system effects are presently the subject of considerable…

Shows general principles, apparatus, sampling times and places, pre-sampling inspection and identification of lots, sampling of bilk grain, sampling of grain in bags, preparation of laboratory sample, and packing, labelling and dispatch of laboratory samples.

This part of ISO 7206 specifies a test method for determining short-term deformation of a press-fit acetabular component for total hip joint replacement under specific laboratory conditions. It also defines the conditions of testing so that the important parameters that affect the components are taken into account and it describes how the specimen is set up for testing. The described method is…

ISO 19581 specifies a screening test method to quantify rapidly the activity concentration of gamma-emitting radionuclides, such as 131I, 132Te, 134Cs and 137Cs, in solid or liquid test samples using gamma-ray spectrometry with lower resolution scintillation detectors as compared with the HPGe detectors (see IEC 61563). This test method can be used for the measurement of any potentially…

ISO 13347-3:2004 applies to industrial fans as defined in ISO 5801 and ISO 13349. It is limited to the determination of airborne sound emission for the specified set-ups. Vibration is not measured, nor is the sensitivity of airborne sound emission to vibration effects determined. The sizes of fan which can be tested in accordance with ISO 13347-3:2004 are limited only by the practical aspects of…

This document provides guidance and considerations for healthcare organizations to deliver diagnostic tests timely and accurately in a pandemic by leveraging innovative approaches to overcome the limitations of laboratory capacity as follows: – mitigating threats encountered in providing diagnostic services during a pandemic; – consideration for quality assurance of diagnostic service provision…

ISO 13347-4:2004 applies to industrial fans as defined in ISO 5801 and ISO 13349. It is limited to the determination of airborne sound emission for the specified set-ups. Vibration is not measured, nor is the sensitivity of airborne sound emission to vibration effects determined. The sizes of the fan, which can be tested in accordance with ISO 13347-4:2004, are limited only by the practical…